AMBIENTECH DD-24V-90W-W-EVO Zero LED Drive Tech Instruction Manual
- May 15, 2024
- AMBIENTECH
Table of Contents
AMBIENTECH DD-24V-90W-W-EVO Zero LED Drive Tech
Quick Specs
- Input Voltage 720VAC
- Output Voltage 72 / 24VDC (Check Label)
- Ambient Temp -30 °C – + 40°C I -86° F – + l04° F
- Environment Dry and Damp
Important Notes
Please Read Before Installation!
- Do not intall this product in metal enclosures as this will prevent wireless signal transmission and operation.
- The LED Driver and system is to be installed and grounded in accordance with the National Electrical Code and local code.
- The system is to be installed and serviced by a qualified licensed electrician.
Before You Begin
Determine the location of system parts :
- Wall Switch
- LED Driver
Note: Max distance between Wall Switch and LED Driver 30m/100 ft.
WARNING
To avoid fire, shock, or death, turn the power Off at the circuit breaker and test to ensure the power is Off before wiring.
Open wiring compartment
Punch knockouts for wiring conduit access
Mount the Driver
Select a suitable location, which can provide adequate support for the weight
of the LED Driver.
Note: Install the LED Driver in a well-ventilated area free from explosive
gases and vapors.
Wire Connections
With the power switched off, connect the wires according to the wiring diagram
below.
Note: If you are connecting more than one wire to each terminal, it is
recommended to form a pigtail connection.
Customer Assistance
For technical questions regarding the installation or operation of this product, please contact our customer support team:
347-334-6368 ext 3
www.ambientechinc.com