AMBIENTECH DriveTech Tunable LED Driver and Dimming Control Installation Guide
- June 10, 2024
- AMBIENTECH
Table of Contents
AMBIENTECH Drive Tech Tunable LED Driver and Dimming Control Installation
Guide
Installation Drive Tech
Input Voltage | VAC120 |
---|---|
Output Voltage | (Label Check (VDC24 / 1 |
Ambient Temp | F104° + – F-86° / C° 40 + – C° – |
Environment | Damp and |
Important Notes
Please Read Before Installation!
- The system is to be installed in accordance with the National Electrical Code or local code.
- The system is to be installed and serviced by a qualified licensed electrician.
- LED Driver must be grounded in accordance with the NEC or local codes.
Before You Begin
Determine the location of system parts:
- Wall Switch
- LED Driver
Note: Max distance between Wall Switch and LED Driver 100m30 ft.
WARNING
To avoid fire shock or death turn the power off at circuit breaker and test to
ensure the power is off before wiring.
Open wiring compartment
Punch knockouts for wiring conduit access
Mount the Driver
Select a support location weight which can provide adequate support for the weight of the LED Driver.
Note: Install the LED Driver in a well-ventilated area free from explosive gases and vapors.
A. Mount the wall bracket
B. Position LED Driver at an angle over the brackets latches
C. Place LED Driver on the bracket latches
D. Align LED Driver on the bracket
E. Install the supplied lock screw
Wire Connections
With the power switched off connect the wires according to the wiring diagram below.
Note: If you are connecting more than one wire to each terminal it is
recommended to form a pigtail connection.
Customer Assistance
For technical questions regarding the installation or operation of this product please contact our customer support team:
347-334-6368 ext3
www.ambientechinc.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>