AMBIENTECH DT-xxV-xxW-W Drive Tone Instruction Manual
- June 10, 2024
- AMBIENTECH
Table of Contents
AMBIENTECH DT-xxV-xxW-W Drive Tone
DriveTone Installation
Quick Specs
| Input Voltage | 120VAC |
|---|---|
| Output Voltage | 12 / 24VDC (Check Label) |
| Ambient Temp | -30 °C – + 40 °C / -86°F – + 104°F |
| Environment | Dry and Damp |
Important Notes
Please Read Before Installation!
- The system is to be installed in accordance with the National Electrical Code or local code.
- The system is to be installed and serviced by a qualified, licensed electrician.
- LED Driver must be grounded in accordance with the NEC or local codes.
Before You Begin
Determine the location of system parts:
- Wall Switch
- LED Driver
Note: Max distance between Wall Switch and LED Driver 30m/100 ft.
WARNING
To avoid fire, shock, or death, turn the power Off at the circuit breaker and test to ensure the power is Off before wiring.
-
Open wiring compartment
-
-
Mount the Driver:
Select a suitable location, which can provide adequate support for the weight of the LED Driver.
Note: Install the LED Driver in a well-ventilated area free from explosive gases and vapors.
A. Mount the wall bracket
B. Position LED Driver at an angle over the bracket’s latches
**C. Place LED Driver on the bracket latches
D. Align LED Driver on the bracket
E. Install the supplied lock screw
**
- Wire Connections
With the power switched Off, connect the wires according to the wiring d iag ram below.
Customer Assistance
For technical questions regarding the installation or operation of this product, please contact our customer support team:
347-334-6368 ext 3
