NUU GARDEN SRD001-01-HS 3PCS Steel Bistro Set Instruction Manual

: June 7, 2024
: NUU GARDEN

Table of Contents

INTRODUCTION
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTION
CARE AND MAINTENANCE
CUSTOMER SERVICE
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

NUU GARDEN SRD001-01-HS 3PCS Steel Bistro Set Instruction Manual

INTRODUCTION

Thanks for purchasing and trusting NUUGARDEN with your home decorating plans. This product is a furniture designed and made by NUUGARDEN Corp.

We are committed to R&D innovation and to create the most refined, diverse choice of outdoor collection.

After unpacking and before every use, check whether the item shows any damages. In addition, check that you have all parts and hardware’s before assembly. If there is any damage, please do not use and just call customer service at 800-257-7108 or send an email to [email protected]. If you do not have all the parts lists, have your dealer contact us and they will be sent to you immediately

This furniture is intended for indoor and outdoor use. Please take time to read and follow the instruction below. Use the item as described in this operating manual. We accept no liability for damages caused by improper use.

INTRODUCTION

| INTRODUCTION

---|---
INTRODUCTION

INTRODUCTION

ASSEMBLY INSTRUCTIONS

Step1 ：Assemble the 2 front legs （ B ） and the 2 behind legs C ） to the seat （ A by 3washers（ D ） and 3 bolts （ E ) respectively.

Step2 : Secure and tighten all the components and attched cushions.

Note : Please do not tighten any bolt until all bolts have been put into right place. If you tighten one bolt, it maybe cause other bolts out of position.

INTRODUCTION |
---|---
| Part Number| Images and Sizes| Qty.
| |
| |
| |
| |
| |
| |
| |
| |

ASSEMBLY INSTRUCTION

Step1: Assembly table legs( B ) to the table top frame( A ) with( B ) washers( D ) and 8 bolts( E ) using wrench.

Step2: Secure and tighten all the components, Attached glass table top( C ) on the table top frame( A )

Note: Please do not tighten any bolt until all bolts have been put into right place.
If you tighten one bolt, it maybe cause other bolts out of position.

CARE AND MAINTENANCE

Follow the instruction for the material of your special product to make sure that it stays in the best shape for as long as possible. The information below is only intended as a general guideline. For more information, please contact us.

Only need to rinse it thoroughly with clean water to wash away dirt and
grime. Never use abrasive cleansers on the furniture, since it can attack the surfaces and leave behind scratch marks.
For the stubborn grime and stains, just use a soft sponge and mild soapy water and then dry it with a cloth or paper towel.
Check the stability of the screws, nuts and nut caps prior to each use. Tighten up them after one to two month’s use whenever required.
• Avoid improper use, and be careful not to scratch or damage the surface with sharp objects.
When you move your furniture, make sure you lift it rather than pulling or pushing it to avoid damaging the foor, legs and mounting.