YEEZOO Two Steps Stool with Handle Installation Guide

Two Steps Stool with Handle
Installation Guide

ASSEMBLY INSTRUCTION

INSTALL THE FIRST CROSS BAR

• Handrail holders must face outwards.
• Use two M7*13mm screws and hex wrench.

INSTALL THE OTHERS TWO CROSS BARS

1. Use four M7*13mm screws and hex wrench.
2. Tighten the three cross bars and keep them level.

INSTALL THE UPPER WOODEN PANEL

• The panel with logo“YEEZOO” is the upper panel, logo outwards.
• Four countersinks face upwards.
• Use four M6*49mm screws and hex wrench to fix the panel.

INSTALL THE FIRST WOODEN PANEL

• Use four M6*49mm screws and hex wrench to fix the panel.
• Check and tighten all screws.

CONNECT THE DETACHABLE HANDRAI

• The bar connection and grab bar are screw thread connected.
• Two grab bar connections are the same, no distinction required.

INSTALL HANDRAIL AND NONS-SLIP PADS

• Insert the handail into the handrail holders.
• Use two M7*13mm screws and hex wrench to fix from it’s bottom.
• Stick the four non-slip pads included under support brackets.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>