YEEZOO Two Steps Bed Stool with Handrails Installation Guide

YEEZOO Two Steps Bed Stool with Handrails

ASSEMBLY INSTRUCTION

 8M713mm

 8M649mm

 4*Non-slip Pads

 1*Open-end Wrench

 2*Sizes Hex Wrench

INSTALL THE OTHERS TWO CROSS BARS

 Handrail holders must face outwards.
Use two M7*13mm screws and hex wrench.
 The cross bars should be level.

Tip: If you find support brackets not level, please adjust the cross bars.

INSTALL THE UPPER WOODEN PANEL

The panel with logo ”YEEZOO” is the upper panel, logo outwards.
Four countersinks and wood surface texture face upwards.
Use four M6*49mm screws and hex wrench to fix the panel.

INSTALL THE FIRST WOODEN PANEL

Four countersinks and wood surface texture face upwards.
Use four M6*49mm screws and he -x wrench to fix the panel.
 Check and tighten all screws.

PREPARE TWO GRAB BARS

The higher one: bar connection and grab bar are screw thread connected.
 The shorter one: No need to assemble.

INSTALL HANDRAILS AND FIX THEM

Insert the handails into the handrail holders.
Use four M7*13mm screws and hex wrench to fix from it’s bottom.
The two grab bars do not distinguish between left and right handrail hold rs.

INSTALL THE FOUR NON -SLIP PADS

 Warm Tipl: Please double check to make sure all screws have been tightened before stepping on.
 Warm Tip2: Please don’t shake th -e handrail or jump on the steps to avoid dangers.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>