Orbic Tab8 4G Prepaid Telstra User Manual

PRODUCT SAFETY & WARRANTY INFORMATION

IMPORTANT SAFETY INFORMATION

Keep the device away from dust, water, damp areas, precipitation, and humidity. Dust, water, iquids, precipitation, and humidity may cause overheating, electrical eakage, and/or device failure. The device, battery, charger, and AC adapter are not waterproof. Keep them away from liquid, fuels, and chemicals. If the device gets wet, do not place the device n an oven, microwave, or dryer, as this will damage the device and could cause a fire or explosion.
Only use the battery and charger approved by the manufacturer. Using other brands may cause battery eakage, overheating, explosion or even fire. Do not use the device where it might cause danger. Do NOT text and drive.

BATTERY USE

Handle and store batteries properly to avoid njury or damage. Most battery issues arise from mproper handling and, particularly, from the continued use of damaged batteries.

• Do not disassemble, open, crush, bend, deform, puncture, or shred the battery.

• Do not modify, remanufacture, attempt to nsert foreign objects into the battery; immerse or expose to water or other liquids, expose to fire, explosion, or other hazards.

• Only use the battery for the system for which it is specified.

• Only use the battery with a charging system that has been qualified with the system per CTIA Certification Requirements for Battery System Compliance to EEE 1725. Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or another hazard.

• Do not short circuit a battery or allow metallic conductive objects to contact battery terminals.

• Replace the battery only with another battery that has been qualified with the system per this standard, IEEE-Std-1725. Use of an unqualified battery may present a risk of fire, explosion, eakage or another hazard.

• Only authorized service providers shall replace battery. (If the battery is non user replaceable).

• Promptly dispose of used batteries n accordance with local regulations.

• Battery usage by children should be supervised.

• Avoid dropping the device or battery. f the device or battery is dropped, especially on a hard surface, and the user suspects damage, take t to a service center for inspection.

• Do not replace an embedded battery pack. Improper replacement may present a risk of fire, explosion, eakage or other hazard.
  Contact the manufacturer for replacement instructions.

• The device recognizes the battery via battery part number.

• The maximum operating temperature range is 0° to 45° (while charging is 40° only).

NOTE:
The battery shall only be serviced by the manufacturer.
CAUTION:
Risk of explosion f battery s replaced by an incorrect type. Dispose of used batteries in accordance with local regulations.

CLEANING AND MAINTENANCE

The device, the battery and the charger are not waterproof. Do not use them in places with high humidity like a bathroom. Avoid spilling any iquids on the device, battery or charger. Use a soft cloth to clean the device, the battery, and the charger. Do not use alcohol, diluted liquid, or benzene to clean the device.

DISPOSAL OF PRODUCT AND BATTERIES

Follow ocal regulations regarding disposal of mobile devices and batteries. In some areas, the disposal of these items in household or business trash may be prohibited. Please follow your ocal regulations and recycle device if required batteries must be recycled or disposed of properly.

FCC SAR WARNING

This model device meets the government’s requirements for exposure to radio waves.
This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government:
The exposure standard for wireless mobile devices employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR imit set by the FCC s 1.6W /kg. Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power evel n all tested frequency bands. The SAR guideline includes a considerable safety margin designed to assure the safety of all persons regardless of age and health.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this model device s on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/fccid after searching on: FCC D: 2ABGHRC8L1T or at http://www.orbic.us/
For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and positions the handset a minimum of Omm from the body. Use of other enhancements may not ensure compliance with FCC RF exposure guidelines.
If you do not use a body-worn accessory and are not holding the device at the ear, position the handset a minimum of Omm from your body when the device is switched on.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation s subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any nterference received, including nterference that may cause undesired operation.

FCC CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
NOTE 1:
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These imits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the nstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, the user is encouraged to try to correct the nterference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

To view device FCC ID on a device, look at the abel n the battery compartment, for devices without a battery door there is an E-label information available by selecting: Settings> About device.
NOTE 2:
Orbic or the manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to the device. Such modifications could void the user’s authority to operate the equipment.
Data transmission is always initiated by software, which s then passed down through the MAC, through the digital and analog baseband, and finally to the RF chip. Several special packets are nitiated by the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter will be on only while one of the aforementioned packets s being transmitted. In other words, this device automatically discontinues transmission in case of either absence of nformation to transmit or operational failure.

ORBIC LIMITED WARRANTY

WHO THIS WARRANTY COVERS
This 12 month imited warranty extends only to the original purchaser of this device within the United States. This warranty s not transferable. This warranty s conditioned upon the proper use of the device.
WHAT THIS WARRANTY COVERS
Orbic offers you a limited warranty that extends for the first twelve (12) month period to the original purchaser from the date of original purchase with proof of purchase. Without valid proof of purchase, Orbic offers a imited warranty extending fifteen (15) months from date of manufacture, which s coded on the device label (“Warranty Period”).
Should the device, nbox accessories or any part during normal consumer usage and conditions be proven defective n material or workmanship that results n device failure, such defect(s) will be repaired or replaced (with new or rebuilt parts) at Orbic’s discretion, without charge for parts or labor directly related to the defect.
WHAT THIS WARRANTY DOES NOT COVER

1. Warranty claims outside of the device warranty Period.
2. Damage or defects caused by using the device other than in the normal course.
3. Defects or damages resulting from accidental, misuse, abnormal use, abnormal conditions, improper storage, unauthorized modifications, unauthorized repair, improper installation, or other acts which are not the fault of Orbic.
4. Defects or damage resulting from excessive force or use of a metallic object when pressing the touch screen.
5. device with altered, defaced or removed serial number.
6. Damage resulting from use of accessories not approved by Orbic.
7. Damage from exposure to moisture, humidity, excessive temperature or extreme environment.
8. Liquid damage due to not properly sealed/locked accessories, ports and or battery atches of water resistance devices.
9. All surfaces and externally exposed parts that are scratched or damaged due to normal customer use.
10. All software, ncluding operating system software, third-party software, applications, and all other software of any kind.
11. Damage caused by ordinary wear and tear of the device.
12. Customer abuse or other physical abuse or mistreatment of device as evidenced by:
    a. Missing required faceplate;
    b. Damaged LCD or Lens (e.g., the device is either broken, cracked, smashed, bleeding, etc.);
    c. IMEl is unreadable electronically or due to missing or altered serial number, MEI and/or reliance data label so as to affect readability;
    d. Missing keys on keypad beyond normal wear and tear;
    e. Unapproved device modification;
    f. Visible device surface physical damage resulting n device being smashed, chewed, gouged, burned or melted;
    g. Liquid damage as evidenced by submission in liquid or any other evidence of iquid ingress, ncluding corrosion of any of the connections and noticeable excessive residue.

WHAT ARE THE LIMITS OF ORBIC’S LIABILITY
THIS LIMITED WARRANTY SETS OUT THE FULL EXTENT OF ORBIC’S RESPONSIBILITIES AND THE EXCLUSIVE REMEDY REGARDING THE DEVICE. ALL IMPLIED WARRANTIES, NCLUDING, WITHOUT LIMITATION, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. N NO EVENT SHALL ORBIC BE LIABLE FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE DEVICE OR FOR, WITHOUT LIMITATION, COMMERCIAL LOSS OF ANY SORT; LOSS OF USE, TIME, DATA, REPUTATION, OPPORTUNITY GOODWILL, PROFITS, OR SAVINGS; INCONVENIENCE; NCIDENTAL, SPECIAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES ARISING FROM THE USE OR INABILITY TO USE THE DEVICE. SOME STATES AND JURISDICTIONS DO NOT ALLOW LIMITATIONS ON HOW LONG AN MPLIED WARRANTY LASTS, OR THE DISCLAIMER OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS AND DISCLAIMERS MAY NOT APPLY TO YOU.
ORBIC MAKES NO WARRANTIES OR REPRESENTATIONS, EXPRESS OR MPLIED, STATUTORY OR OTHERWISE, AS TO THE QUALITY, CAPABILITIES, OPERATIONS, PERFORMANCE OR SUITABILITY OF ANY THIRD-PARTY SOFTWARE OR EQUIPMENT USED IN CONJUNCTION WITH THE DEVICE, OR THE ABILITY TO INTEGRATE ANY SUCH SOFTWARE OR EQUIPMENT WITH THE DEVICE DISTRIBUTED BY ORBIC OR OTHERWISE. RESPONSIBILITY FOR THE QUALITY CAPABILITIES, OPERATIONS, PERFORMANCE AND SUITABILITY OF ANY SUCH THIRD- PARTY SOFTWARE OR EQUIPMENT RESTS SOLELY WITH THE USER AND THE DIRECT VENDOR, OWNER OR SUPPLIER OF SUCH THIRD-PARTY SOFTWARE OR EQUIPMENT.
Nothing in the device nstructions or nformation shall be construed to create an express warranty of any kind with respect to the device. No agent, employee, dealer, representative or reseller is authorized to modify or extend this Limited Warranty or to make binding representations or claims, whether in advertising, presentations or otherwise, on behalf of Orbic regarding the device or this Limited Warranty.
This Limited Warranty gives you specific legal rights and you may also have other rights that vary from state to state.
WHAT ARE THE PROCEDURES FOR RESOLVING DISPUTES
ALL DISPUTES WITH ORBIC ARISING IN ANY WAY FROM THIS LIMITED WARRANTY OR THE SALE, CONDITION OR PERFORMANCE OF THE DEVICE SHALL BE RESOLVED EXCLUSIVELY THROUGH FINAL AND BINDING ARBITRATION, AND NOT BY A COURT OR JURY. Any such dispute shall not be combined or consolidated with a dispute nvolving any other person’s or entity’s devices or claim and, specifically, without limitation of the foregoing, shall not under any circumstances proceed as part of a class action. The arbitration shall be conducted before a single arbitrator, whose award may not exceed, in form or amount, the relief allowed by applicable law. The arbitration shall be conducted according to the American Arbitration Association (AAA) Commercial Arbitration Rules applicable to consumer disputes. This arbitration provision is entered pursuant to the Federal Arbitration Act. The aws of the State of New York, without reference to ts choice of laws principles, shall govern the nterpretation of the Limited Warranty and all disputes that are subject to this arbitration provision. The arbitrator shall decide all issues of interpretation and application of this arbitration provision and the Limited Warranty. This arbitration provision also applies to claims against Orbic’s employees, representatives and affiliates if any such claim arises from the device’s sale, condition or performance.
HOW TO GET WARRANTY SERVICE
To obtain warranty service, please call the following telephone number from anywhere in the continental United States: 1-877-872-4555.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>