Orbic Chromebook Laptop User Manual
- June 5, 2024
- Orbic
Table of Contents
Orbic Chromebook Laptop
Important Safety Information
Keep the product away from dust, water, damp areas, precipitation and
humidity. Dust, water, liquids, precipitation and humidity may cause
overheating, electrical leakage, and/or product failure. The product, battery,
charger and AC adapter are not waterproof.
Keep them away from liquid, fuels and chemicals. If the product
gets wet, do not place the product in an oven, microwave or dryer,
as this will damage the product and could cause a fire or explosion.
Only use the battery and charger approved by the manufacturer. Using other
brands may cause battery leakage, overheating, explosion or even fire. Do not
use the product where it might cause danger.
Battery Use
Handle and store batteries properly to avoid injury or damage.
Most battery issues arise from improper handling of removable battery and,
particularly, from the continued use of damaged batteries.
- Do not disassemble or open, crush, bend or deform, puncture, or shred.
- Do not modify or remanufacture, attempt to insert foreign objects into the battery, immerse or expose to water or other liquids, or expose to excessive heat, fire, or other hazard. Only use the battery in the system for which it was specified.
- Only use the battery with a charging system that has been qualified with the system per this standard.
- Use of an unqualified battery or charger may present a risk of fire, explosion, leakage, or other hazard.
- Do not short-circuit a battery or allow metallic or conductive objects to contact the battery terminals.
- Replace the battery only with another battery that has been qualified with the system per CTIA Certification Requirements for Battery System Compliance to IEEE 1625.
- Use of an unqualified battery may present a risk of fire, explosion, leakage, or other hazard.
- Promptly dispose of used batteries in accordance with local regulations.
- Battery usage by children should be supervised.
- Follow the explanation of a security implementation per IEEE 1625 Clause 10.3.1.
- Avoid dropping the host or battery. If the host or battery is dropped, especially on a hard surface, and the end user suspects damage, take it to a service center for inspection.
- Improper battery use may result in a fire, explosion, leakage, or other hazard.
- The recommended charging temperature of the device is 0° C to 45° C. The recommended discharging temperature of the device is°0 Cto 60° C.
- The storage and operations temperature ranges from 0°C to 40° C.
Note: The battery shall only be serviced by the manufacturer.
CAUTION : Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries in accordance with local regulations. Risk of fire and burns. Do not open, crush, heat above 60° C or incinerate. Follow manufacturer’s instructions
Cleaning and Maintenance
The product, the battery and the charger are not waterproof. Do not use them
in places with high humidity like a bathroom and also avoid spilling any
liquids on the product, battery or charger. Use a soft cloth to clean the
product, the battery and the charger. Do not use alcohol, diluted liquid or
benzene to clean the product.
Disposal of Product and Batteries
Follow local regulations regarding disposal of mobile devices and batteries.
In some areas, the disposal of these items in household or business trash may
be prohibited. Please follow your local regulations and recycle product if
required Batteries must be recycled or disposed of properly.
Certification Information (RoHS)
We at Orbic take our social responsibility seriously and are committed to the
cause of serving our environment. It is in keeping with these commitments that
we are proud to state that Orbic products are RoHS compliant.
FCC SAR Warning
This model product meets the government’s requirements for exposure
to radio waves.
This product is designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal Communications
Commission of the U.S. Government:
The exposure standard for wireless products employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is
1.6W /kg.
Tests for SAR are conducted using standard operating (10 mm) positions
accepted by the FCC with the product transmitting at its highest certified
power level in all tested frequency bands. The SAR guideline includes a
considerable safety margin designed to assure the safety of all persons
regardless of age and health.
The FCC has granted an Equipment Authorization for this model product with all
reported SAR levels evaluated as in compliance with the FCC RF exposure
guidelines. SAR information on this model product is on file with the FCC and
can be found under the Display Grant section of https://www. fcc.gov/oet/fccid
after searching on: FCC ID: 2ABGH -RC116LCB or at http://www.orbic.us/
FCC Statement
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This product may not cause harmful interference, and
2. This product must accept any interference received, including interference
that may cause undesired operation.
note :
This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This product generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this product does cause harmful interference to radio or
television reception, which can be determined by turning the product off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE2:
Orbic or the manufacturer is not responsible for any radio or TV interference
caused by unauthorized modifications to the product. Such modifications could
void the user’s authority to operate the equipment. Data transmission is
always initiated by software, which is then passed down through the MAC,
through the digital and analog baseband, and finally to the RF chip. Several
special packets are initiated by the MAC. These are the only ways the digital
baseband portion will turn on the RF transmitter, which it then turns off at
the end of the packet. Therefore, the transmitter will be on only while one of
the aforementioned packets is being transmitted. In other words, this device
automatically discontinues transmission in case of either absence of
information to transmit or operational failure.
Orbic Limited Warranty
WHO THIS WARRANTY COVERS
This 12 month limited warranty extends only to the original purchaser of this
product within the United States. This warranty is not transferable. This
warranty is conditioned upon the proper use of the product.
WHAT THIS WARRANTY COVERS
Orbic offers you a limited warranty that extends for the first twelve
(12) month period to the original purchaser from the date of original purchase
with proof of purchase. Without valid proof of purchase, Orbic offers a
limited warranty extending fifteen (15) months from date of manufacture, which
is coded on the product label (“Warranty Period”).
Should the product, inbox accessories or any part during normal consumer usage
and conditions be proven defective in material or workmanship that results in
product failure, such defect(s) will be repaired or replaced (with new or
rebuilt parts) at Orbic’s discretion, without charge for parts or labor
directly related to the defect.
WHAT THIS WARRANTY DOES NOT COVER
- Warranty claims outside of the product warranty Period.
- Damage or defects caused by using the product other than in the normal course.
- Defects or damages resulting from accidental, misuse, abnormal use, abnormal conditions, improper storage, unauthorized modifications, unauthorized repair, improper installation, or other acts which are not the fault of Orbic.
- Defects or damage resulting from excessive force or use of a metallic object when pressing the touch screen.
- Product with altered, defaced or removed serial number.
- Damage resulting from use of accessories not approved by Orbic.
- Damage from exposure to moisture, humidity, excessive temperature or extreme environment.
- Liquid damage due to not properly sealed/locked accessories, ports and or battery latches of water resistance devices.
- All surfaces and externally exposed parts that are scratched or damaged due to normal customer use.
- All software, including operating system software, third-party software, applications, and all other software of any kind.
- Damage caused by ordinary wear and tear of the Product.
- Customer abuse or other physical abuse or mistreatment of Product as evidenced by:
- Missing required faceplate.
- Damaged LCD or Lens (e.g., the product is either broken, cracked, smashed, bleeding, etc.
- IMEI is unreadable electronically or due to missing or altered serial number, IMEI and/or reliance date label so as to affect readability.
- Missing keys beyond normal wear and tear.
- Unapproved Product modification.
- Visible Product surface physical damage resulting in product being smashed, chewed, gouged, burned or melted.
- Liquid damage as evidenced by submission in liquid or any other evidence of liquid ingress, including corrosion of any of the connections and noticeable excessive residue.
WHAT ARE THE LIMITS OF ORBIC’S LIABILITY
THIS LIMITED WARRANTY SETS OUT THE FULL EXTENT OF ORBIC’S RESPONSIBILITIES AND
THE EXCLUSIVE REMEDY REGARDING THE PRODUCT. ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, ARE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY. IN
NO EVENT SHALL ORBIC BE LIABLE FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF
THE PRODUCT OR FOR, WITHOUT LIMITATION, COMMERCIAL LOSS OF ANY SORT; LOSS OF
USE, TIME, DATA, REPUTATION, OPPORTUNITY, GOODWILL, PROFITS, OR SAVINGS;
INCONVENIENCE; INCIDENTAL, SPECIAL, CONSEQUENTIAL, OR PUNITIVE DAMAGES ARISING
FROM THE USE OR INABILITY TO USE THE PRODUCT. SOME STATES AND JURISDICTIONS DO
NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, OR THE DISCLAIMER
OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS
AND DISCLAIMERS MAY NOT APPLY TO YOU.
ORBIC MAKES NO WARRANTIES OR REPRESENTATIONS, EXPRESS
OR IMPLIED, STATUTORY OR OTHERWISE, AS TO THE QUALITY, CAPABILITIES,
OPERATIONS, PERFORMANCE OR SUITABILITY OF ANY THIRD-PARTY SOFTWARE OR
EQUIPMENT USED IN CONJUNCTION WITH THE PRODUCT, OR THE ABILITY TO INTEGRATE
ANY SUCH SOFTWARE OR EQUIPMENT WITH THE PRODUCT DISTRIBUTED BY ORBIC OR
OTHERWISE. RESPONSIBILITY FOR THE QUALITY, CAPABILITIES, OPERATIONS,
PERFORMANCE AND SUITABILITY OF ANY SUCH THIRD-PARTY SOFTWARE OR EQUIPMENT
RESTS SOLELY WITH THE USER AND THE DIRECT VENDOR, OWNER OR SUPPLIER OF SUCH
THIRD- PARTY SOFTWARE OR EQUIPMENT.
Nothing in the product instructions or information shall be construed to
create an express warranty of any kind with respect to the product. No agent,
employee, dealer, representative or reseller is authorized to modify or extend
this Limited Warranty or to make binding representations or claims, whether in
advertising, presentations or otherwise, on behalf of Orbic regarding the
product or this Limited Warranty.
This Limited Warrant gives you specific legal rights and you may also have
other rights that vary from state to state.
WHAT ARE THE PROCEDURES FOR RESOLVING DISPUTES?
ALL DISPUTES WITH ORBIC ARISING IN ANY WAY FROM THIS LIMITED WARRANTY OR THE
SALE, CONDITION OR PERFORMANCE OF THE PRODUCT SHALL BE RESOLVED EXCLUSIVELY
THROUGH FINAL AND BINDING ARBITRATION, AND NOT BY A COURT OR JURY.
Any such dispute shall not be combined or consolidated with a dispute
involving any other person’s or entity’s products or claim and, specifically,
without limitation of the foregoing, shall not under any circumstances proceed
as part of a class action. The arbitration shall be conducted before a single
arbitrator, whose award may not exceed, in form or amount, the relief allowed
by applicable law. The arbitration shall be conducted according to the
American Arbitration Association (AAA) Commercial Arbitration Rules applicable
to consumer disputes. This arbitration provision is entered pursuant to the
Federal Arbitration Act. The laws of the State of New York, without reference
to its choice of laws principles, shall govern the interpretation of the
Limited Warranty and all disputes that are subject to this arbitration
provision. The arbitrator shall decide all issues of interpretation and
application of this arbitration provision and the Limited Warranty. This
arbitration provision also applies to claims against Orbic’s employees,
representatives, and affiliates if any such claim arises from the product’s
sale, condition, or performance.
HOW TO GET WARRANTY SERVICE
To obtain warranty service, please call the following telephone number from
anywhere in the continental United States:
1-877-872-4555
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>