KOHLER T35910-3-SN Two Handle Wall Mount Tub Filler User Guide
- June 17, 2024
- Kohler
Table of Contents
Record your model number:
T35910-3-SN Two Handle Wall Mount Tub Filler
|
---|---
Follow all local plumbing and building codes.
Turn OFF the water supplies.
1A. Sealant Tape
1B. Emery Paper
1C. 1/2 NPT Pipe Nipple (Threaded Spout)
1D. 1/2″ Copper Tube (Slip-Fit Spout)
1E. 1/8″ Hex Wrench
1F. Silicone Sealant
2A. Measure distance “X” to the finished wall.
2B. Use the short adapter if “X” = 9/16″ (14 mm) – 1-1/16″ (27 mm).
2C. Use the long adapter if “X” = 1-1/16″ (27 mm) – 1-9/16″ (40 mm).
3A. Use the key to securely tighten the adapters.
5A. The spline should extend between 1″ (25 mm) and 1-1/2″ (38 mm) from the
finished wall. Measure and mark.
6A. Remove the spline adapter. Cut at the nearest groove.
9A. Orient handles to the closed position.
10A. To adjust handle position, remove the spline adapter. Rotate and
reinstall.
11A. Slip-Fit Spout: Install the tube 1-1/2″ (38 mm) from the finished wall.
12A. Use emery paper to remove burrs. Clean debris.
13A. Slip-Fit Spout: Loosen the setscrew. Install the spout. Tighten the
setscrew.
14A. Threaded Spout: Apply sealant tape to the threads. Install 1-1/2″ (38 mm)
from the finished wall.
15A. Threaded Spout: Loosen the setscrew. Thread the spout. Tighten the
setscrew.
16A. Apply silicone sealant.
18A. Run water to flush debris.
Need help? Contact our Customer Care Center.
- USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537
- Service parts: kohler.com/serviceparts
- Care and cleaning: kohler.com/clean
- Patents: kohlercompany.com/patents
This product is covered under the KOHLER® Faucet Lifetime Limited Warranty, found at kohler.com/warranty. For a hardcopy of warranty terms, contact the Customer Care Center.
©2023 Kohler Co.
1558412-2-A
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>