LOVMOR 2DB18-E Drawer Base Cabinet Instruction Manual
- June 17, 2024
- LOVMOR
Table of Contents
LOVMOR 2DB18-E Drawer Base Cabinet
Specifications
- Model: 2DB18-E, 2DB24-E
- Drawer Base Cabinet
- Drawer Side Panels: G1, G2 (left and right)
- Drawer Back Panel: I
- Box Side Panels: A1, A2 (left and right)
- Box Bottom Panel: B
- Box Back Panel: C
- Face Frame: D
- Toe Kick Panel: E
Product Usage Instructions
Caution:
Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them. Keep hardware away from children during unpacking and assembly. Two adults are recommended for assembly.
Assembly Tips:
- Follow the instructions in the manual carefully and strictly to ensure proper assembly and operation.
- Do not tighten all screws until all adjacent parts are properly connected.
- Do not discard extra screws; refer to the product for screw hole positions.
Hardware Contents:
- Glide and runner profile x 4
- Adjustable drawer clips x 4
- Wood corner block x 4
- Corner brace x 11
- Rubber bumper x 8
Tools Required (Not Included):
- List of tools here –
Installation Overview:
- Step-by-step installation guide here –
Drawer Usage:
- To insert the drawer, push it onto the extended runner until a click is heard to secure it.
- Ensure the hook on each runner fits into the corresponding holes on the drawer back panel.
- To level the drawer, adjust using the green spur gears for left/right, up/down, and inside/outside movements.
- To remove the drawer, simultaneously push the green clips to unlock the drawer clips.
FAQ
Q: Where can I get assistance if needed?
A: For assistance, please contact the customer service team at the retailer where you purchased the product.
Parts
| PART | DESCRIPTION |
|---|---|
| A1 | Box side panel – left |
| A2 | Box side panel – right |
| B | Box bottom panel |
| C | Box back panel |
| D | Face frame |
| E | Toe kick panel |
| PART | DESCRIPTION |
|---|---|
| F | Drawer face panel |
| G1 | Drawer side panel – left |
| G2 | Drawer side panel – right |
| H | Drawer bottom panel |
| I | Drawer back panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws.Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
Use 1/2” round head phillips screw x 10
Use 1/2” round head phillips screw x 10
- Insert the drawer on the extended runner. To secure the drawer clips with the runner, push the drawer in. Upon successful locking, a click can be heard.
- Ensure that the hook on each runner profile fits into the corresponding holes on the drawer back panel
- To level the drawer, use the green spur gears 1 to adjust drawer left and right, the green spur gears 2 to adjust drawer up and down, and the green spur gears 3 to adjust drawer inside and outside
- To take the drawer out, push the green clips at the same time to unlock drawer clips
Dear customers,
Thank you for purchasing our product. If you require assistance, please contact the customer service team at the retailer where you purchased the product. The customer service team will be happy to assist you.