LOVMOR SB30-E Kitchen Sink Base Cabinet Instruction Manual
- June 17, 2024
- LOVMOR
Table of Contents
LOVMOR SB30-E Kitchen Sink Base Cabinet
Product Information
- Specifications:
- Model Numbers: SB30-E, SB33-E, SB36-E, VS30-E, VS36-E
- Parts Included: A1, A2, B, C, D, E, J
- Hardware: Soft-close hinges, wood corner blocks, corner braces, screws
- Tools Required: Phillips screwdriver (not included)
Product Usage Instructions
- Caution:
- Be sure to carefully remove all parts from the carton and ensure no damage.
- Keep hardware away from children during unpacking and assembly.
- Assembly is recommended with two adults.
- Assembly Steps:
- Step 1: Use 1/2 round head Phillips screw x 10 to attach A1 to EE.
- Step 2: Use 1/2 round head Phillips screw x 10 to attach A2 to EE.
- Hardware Contents:
- Soft-close hinge x 4
- Wood corner block x 4
- Corner brace x 13
- Various screws are included for assembly
- Frequently Asked Questions (FAQ)
- Q: What should I do if the door is not level after installation?
- A: Adjust the hinge by turning the screw clockwise to extend or counterclockwise to shorten.
- Q: Where can I get assistance if needed?
- A: Please contact the customer service team at the retailer where you purchased the product for assistance.
PART DESCRIPTION
| PART | DESCRIPTION |
|---|---|
| A1 | Box side panel – left |
| A2 | Box side panel – right |
| B | Box bottom panel |
| C | Box back panel |
| D | Face frame |
| E | Toe kick panel |
| J | Door panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws. Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
GG 1” Flat head Phillips screw x 4
HH Rubber bumper x 4
TOOLS REQUIRED
TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
Dear customers,
- Thank you for purchasing our product.
- If you require assistance, please contact the customer service team at the retailer where you purchased the product.
- The customer service team will be happy to assist you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>