LOVMOR VDDB60-E Bathroom Vanity Single Sink Storage Unit Instruction Manual
- June 17, 2024
- LOVMOR
Table of Contents
Vanity Double
Drawer Base Cabinet
Instruction Manual
MODEL: VDDB60-E
| PART | DESCRIPTION |
|---|---|
| A1 | Box side panel – left |
| A2 | Box side panel – right |
| B | Box bottom panel |
| C | Box back panel |
| D | Face frame |
| E | Toe kick panel |
| F1 | Drawer face panel |
| F2 | Drawer face panel |
| G1 | Drawer side panel – left |
| G2 | Drawer side panel – right |
| H | Drawer bottom panel |
| I | Drawer back panel |
| J | Door panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws.Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
AA Glide and runner profile x 12
BB Adjustable drawer clips x 12
CC Soft – close hinge x 4
Be careful the length of the screws.
DD Wood corner block x 4
EE
Corner brace x 13 GG 1” Flat head
Phillips screw x 6 HH Rubber bumper x 28 TOOLS REQUIRED (NOT
INCLUDED)
INSTALLATION OVERVIEW
24a Be
careful of the screw type. Use 3/8” flat head phillips screw x 4
26b Insert the
drawer on the extended runner. To secure the drawer clips with the runner,
push the drawer in. Upon successful locking, a click can be heard.
26c Ensure that
the hook on each runner profile fits into the corresponding holes on the
drawer back **panel. 26d To level the drawer, use the green spur gears 1 to
adjust drawer left and right, the green spur gears 2 to adjust drawer up and
down, and the green spur gears 3 to adjust drawer inside and
outside.
26f To take the drawer out, push the green clips at the same
time to unlock drawer clips. 
27a Use 1/2” flat head phillips screw x
8
28c If the door is not level when it is installed, the
customer will need to turn the screw clockwise to extend the hinge or
counterclockwise to shorten the hinge.
30 1” Flat Head Phillips Screw x 8 (2
screws for 1 corner block)
Dear customers,**
Thank you for purchasing our product. If you require assistance, please contact the customer service team at the retailer where you purchased the product. The customer service team will be happy to assist you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>