LOVMOR W1520GD-E Wall Cabinet Instruction Manual
- June 17, 2024
- LOVMOR
Table of Contents
Wall Cabinet Instruction Manual
MODEL: W1530GD-E
Glass Is Not Included
W1520GD-E Wall Cabinet
| PART | DESCRIPTION |
|---|---|
| A1 | Box side panel – left |
| A2 | Box side panel – right |
| B | Box bottom panel |
| C | Box back panel |
| D | Face frame |
| J | Door panel |
| K | Adjustable Shelf |
| L | Box top panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected.
Please do not throw away extra screws.Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
CC Soft-close hinge x 2
Be careful the length of the screws.
EE Corner brace x 10
FF Adjustable shelf clip x 8
GG 1” Flat head Phillips screw x 4
HH Rubber bumper x 2
TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
If the door is not level when it is installed, the customer will need to turn the screw clockwise to extend the hinge or counterclockwise to shorten the hinge.
Some products may have hinges pre-installed.
To reverse the door, unscrew the 3/4″ round head phillips screws from each
hinge and remove the door panel. Then, reverse the door panel and drill the
3/4” round head phillips screws to each hinge through the pre-drilled holes to
tighten the hinges with cabinet face frame.
GLASSDOOR CUTOUT SPECIFICATIONS
Height Configuration:
Door Height – (2 x Door Style Rail Width) + 1½”
Width Configuration:
Door Width – (2 x Door Style Stile Width) + 1½”
| Door Style | Rail Width | Stile Width |
|---|---|---|
| Shaker | 2 ¾” | 2 ¾” |
| Traditional | 3″ | 3″ |
| Cameo | 3″ | 3″ |
*Door height and width information is located in the Specification Manual.
DISCLAIMER: This formula is to be used as an estimation tool only.We
recommend that physical measurements are taken prior to ordering your
inserts.We cannot guarantee the exact dimensions determined when using the
formula provided.
Dear customers,
Thank you for purchasing our product. If you require assistance, please
contact the customer service team at the retailer where you purchased the
product. The customer service team will be happy to assist you.