LOVMOR 3DB12-E Drawer Base Cabinet Instruction Manual
- June 17, 2024
- LOVMOR
Table of Contents
LOVMOR 3DB12-E Drawer Base Cabinet
MODEL : 3DB12-E 3DB15-E 3DB18-E 3DB21-E
DESCRIPTION
| PART | DESCRIPTION |
|---|---|
| A1 | Box side panel – left |
| A2 | Box side panel – right |
| B | Box bottom panel |
| C | Box back panel |
| D | Face frame |
| E | Toe kick panel |
| PART | DESCRIPTION |
| --- | --- |
| F1 | Drawer face panel |
| F2 | Drawer face panel |
| G1 | Drawer side panel – left |
| G2 | Drawer side panel – right |
| H | Drawer bottom panel |
| I | Drawer back panel |
CAUTION
- Be sure to carefully remove all parts from the carton and ensure that there are no damages to any of them.
- The hardware should be kept away from children when unpacking and assembling this product. Two adults are recommended for assembly.
- Follow the instructions in the instruction manual carefully and strictly to ensure that the product is assembled and operates as intended.
- Do not tighten all the screws until all the adjacent parts have been properly connected. Please do not throw away extra screws.Please refer to the actual product for the screw hole position.
HARDWARE CONTENTS
TOOLS REQUIRED (NOT INCLUDED)
INSTALLATION OVERVIEW
- Use 1/2” round head phillips screw x 10
- Use 1/2” round head phillips screw x 10
- Use 1/2” round head phillips screw x 2
- Use 1/2” round head phillips screw x 2
- Use 1/2” round head phillips screw x 8
- Use 1/2” round head phillips screw x 12
- Use 5/8” flat head phillips screw x 12
- Use 5/8” flat head phillips screw x 12
- Use 5/8” flat head phillips screw x 4 Be careful of the screw type.
- Use 3/8” flat head phillips screw x 4 Be careful of the screw type.
- Insert the drawer on the extended runner. To secure the drawer clips with the runner, push the drawer in. Upon successful locking, a click can be heard.
- Ensure that the hook on each runner profile fits into the corresponding holes on the drawer back panel.
- To level the drawer, use the green spur gears 1 to adjust the drawer left and right, the green spur gears 2 to adjust the drawer up and down, and the green spur gears 3 to adjust the drawer inside and outside.
- To take the drawer out, push the green clips at the same time to unlock the drawer clips.
- Use 1” flat head phillips screw x 8 (2 screws for 1 corner block)
Dear customers,
Thank you for purchasing our product. If you require assistance, please
contact the customer service team at the retailer where you purchased the
product. The customer service team will be happy to assist you.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>