Metalux LED Round Flush Mount Fixture User Guide

: June 17, 2024
: METALUX

Table of Contents

Metalux LED Round Flush Mount Fixture User Guide
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Metalux LED Round Flush Mount Fixture User Guide

FMWRCCR Series

White Round LED Flushmount

Instruction Manual

Questions? 1-800-334-6871 ConsumerProducts@cooperlighting.com

PACKAGING CONTENTS

Packaging Contents

ITEMS REQUIRED

(Purchase separately)

Phillips Head Screwdriver

WARNINGS AND CAUTIONS

Safety Information • Read carefully for your protection

Turn off the power at fuse or circuit breaker box before installation and maintenance.
Wear rubber-soled shoes and work on a sturdy ladder.
NOTE: This fixture should be used on a 120-Volt fused circuit. (Check fixture labeling)
Fixture must be installed according to National Electric Code and local building codes.
Ground fixture to avoid potential electric shock.
Handle metal parts carefully to prevent cuts.
To avoid a hazard to children, account for all parts and destroy all packing materials.
If you are unsure about wiring, consult a qualified electrician.
If any part is missing or damaged, do not attempt to assemble, install or operate the product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user’s authorization to operate this equipment.

SAVE THESE INSTRUCTIONS.

WIRING AND FIXTURE INSTALLATION

TURN POWER OFF AT MAIN FUSE/ BREAKER BOX. Carefully open carton, remove fixture from carton.
Attach the mounting bracket to the JBOX by inserting the short #8-32 x 9/16” screws into the slots of the bracket and threading into JBOX.
Add the longer M4 x 23mm screws to the mounting bracket in either the outer or inner thread hole locations leaving about 1 in. of space between the screw head and the mounting bracket.
Connect the fixture wires to the supply wires. Black to black, white to white, and green to bare / green ground wire.
Lift fixture pan up toward ceiling and carefully tuck wires into outlet box. Align keyholes on fixture pan with long screws, then twist fixture pan until the long screws engage the narrow end of the keyholes. Tighten long screws to secure pan.
Align the tabs on fixture pan with the channels on diffuser, then insert diffuser into fixture pan. Carefully twist the diffuser clockwise until secure. *19 inch version secures with tabs.
To clean diffuser, use a mild detergent and water. Wipe and allow to air dry.
Restore power to the electrical box. Turn the light switch on to activate the fixture.
Turn off light switch and toggle CCT select control to desired color temperature (CCT.)
Turn on light switch to see fixture lumen color temperature chosen. Repeat steps 7 & 8 until desired CCT is reached.