Waterdrop WD-CFF-01 Countertop Stainless Steel Faucet Filtration System Installation Guide

Waterdrop WD-CFF-01 Countertop Stainless Steel Faucet Filtration System Installation Guide

Model: WD-CFF-01
System Model: WD-CTF-01/ WD-CTF-02

Filter Life: up to 12 months or 8,000 gallons, whichever comes first.

Tested and Certified by IAPMO R &T against NSF/ANSI 42 in Model WD-CTF-01 /WD-CTF-02 for the reduction of the claims specified on the Performance Data Sheet, and NSF/ANSI 372 (≤0.25% lead

Operating Specifications
Operating Temperature : 41-100°F (5-38°C)
Operating Pressure : 15-100 psi / 100-689 Kpa
Flow Rate: 1.0 gpm/3.8 lpm
NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Storage and Maintenance
Replace your filter every 12 months or 8,000 gallons to prevent bacteria and fungus growth in your filter, supply lines, and storage tank. Keep your unused filter in a cool, dark, and dry place until you need it.

Installation and Replacement Procedures **

**

Place the system in the water sink, and use the wrench to unscrew the filter housing from the top (there will be water between the filter housing and the base).

Remove the expired filter from the system and insert the new filter into the base. Make sure the sealing ring has been installed firmly, and the plastic film of the new filter has been removed.

Screw the filter housing into the base by hand and tighten it with the wrench.

Turn on the faucet and flush the new filter for 3-5 minutes.

NOTE: Before first use, flush the new filter with cold water in the “pure” position for 3-5 minutes.

Warning

• Do not use with water above 100°F/38°C.
• To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the operating specifications and instructions.
• This filter unit must be replaced on a regular basis.
• Failure to follow instructions and operating specifications will void your warranty. Further, the manufacturer assumes no responsibility or liability for damages arising out of misuse of the product. Exequently Asked Questions

Frequently Asked Questions:

Why does the filtered water run quite slowly?

The water pressure is not high enough, or the filter is clogged. Please check whether the water pressure is abnormal or whether the filter is clogged.

Q: Why isn't the TDS value reduced after filtration?

: TDS stands for total dissolved solids. It is composed of inorganic salts and a small amount of organic matter. This system cannot reduce the TDS value because it removes harmful substances while keeping beneficial trace elements, which can increase the TDS value.

Q: Why does water leak between the mounting base and the faucet?

Remove the filtration system from the faucet and check on whether the O-ring at the connection is placed correctly. Ensure that the thread between the faucet and the filtration system is screwed in firmly so that the O-ring can work.

Q: Why is the water leaking or dripping?

: Check whether the selected adapter is correct or whether the adapter sealing ring and the base sealing ring are installed firmly. Check whether the spout and the stainless-steel base are properly installed in place. Flush the filter for 3-5 minutes to activate it, and then there will be no leaks or drips.

Performance data sheet
System Model   No.: WD-CTF-01/ WD-CTF-02

Substance reduction:
The system has been tested and certified by the IAPMO R&T International according to NSF/ANSI Standard 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specified by NSF/ANSI Standard 42. While testing was performed under standard laboratory conditions, actual performance may vary.

NSF/ANSI Standard 42 – Aesthetic Eects

Substance| Influent Challenge Concentration| Percent Reduction| Product Water Concentration| U.S. EPA Level/NSF Maximum Permissible Product Water Concentration
Chlorine Taste and Odor| 2.0 mg/L| 97.63| ND| 250%

Do not use with water that is micro biologically unsafe or of unknown water quality without adequate disinfection  before or after the system.

Manufacturer Technical Support
Tel : 1-888-352-3558 (U.S.)
E-mail : service@waterdropfilter.com

Made in China V041 Qingdao Ecopure Filter Co., Ltd

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>