Waterdrop WD-FF-03A Carbon Block Faucet Replacement Filter Installation Guide

: June 17, 2024
: Waterdrop

Table of Contents

Operating Specifications
Storage and Maintenance
Installation and Replacement Procedures
Warning
Frequently Asked Questions
Customer Support
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Waterdrop WD-FF-03A Carbon Block Faucet Replacement Filter

Waterdrop WD-FF-03A Carbon Block Faucet Replacement
Filter

Operating Specifications

Operating Temperature: 41-100°F (5-38°C)
Operating Pressure: 15-100 psi (100-689 kPa)
Rated Capacity: 320 gallons (1,200 liters)
Flow Rate: 0.5 gpm (2 1pm)

NOTE: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

Storage and Maintenance

Replace your filter every 3 months or 320 gallons to prevent bacteria and fungus growth in your filter, supply lines, and storage tank.
Keep your unused filter in a cool, dark, and dry place until you need them.

Installation and Replacement Procedures

A. The installation method of stainless-steel faucet filtration system is as follows:

Twist off the filter base and remove the expired filter.
Take out the new filter and press it into the filter base . Ensure the sealing ring is in place.
Twist the filter base with the filter top cover .
Switch the lever to the level position and flush for 3 minutes.

B. The installation method of other faucet filtration systems is as follows:

Twist the Filter Base from the Mounting Base.
Twist the filter top cover off and take out the old filter.
Insert new filter into the filter base.
Twist the filter top cover on.
Align the slot of filter base with the slot of mounting base.
Insert filter base into mounting base and rotate 90° upward.

NOTE: Before first use, run cold water for 1 minute in “pure” position to flush the filter.

Warning

Do not use with water above 100°F/38°C.
To reduce the risk of property damage due to water leakage, this filter MUST be installed in accordance with the operating specifications and instructions.
This filter unit must be replaced on regular basis.
Failure to follow instructions and operating specifications will void your warranty. Further, manufacturer assumes no responsibility or liability for damages arising out of misuse of the product.

Frequently Asked Questions

1. Q: Why does black water come out after turning on the faucet for the first time?
A: Because the product adopts coconut activated carbon block to filter water, and there are some carbon particles on the carbon block surface. When it is first used, the carbon particles are flushed into the purified water to cause black water, which is a normal phenomenon. Please flush it for a minute and then use it. The purified water cannot be drunk while flushing.

2. Q: Why does the filtered water run quite slowly?
A: The filter cartridge may be clogged. Replace the filter cartridge.

3. Q: Why does the unfiltered water run quite slowly?
A: There may be dirt in filter steel mesh. Clean the filter steel mesh.

4. Q: Why does the water taste funny?
A: The filter cartridge is not installed appropriately, or it should be replaced. Please re-install it in a correct way. If there is still bad taste, please replace it.