SOLIGHT WO798-1-B LED Lighting with Remote Control Instructions
- June 17, 2024
- Solight
Table of Contents
WO798-1-B LED Lighting with Remote Control
Instructions for use of light panel WO798-1-B
Dear customer, thank you for purchasing our product. Please read the following
instructions carefully and follow them to serve you safely and to your full
satisfaction. This will prevent misuse or damage. Avoid unprofessional
handling of this appliance and always observe the electrical appliance usage
guidelines. Do not hang or cover the luminaire with anything. Keep the
instruction manual carefully. Installation may only be carried out by a
qualified worker qualified in accordance with Decree No 50/1978 Coll., as
amended, at least a worker who is knowledgeable in accordance with § 5 of
Decree No 50/1978 Coll., as amended.
PACKAGING CONTENT
TECHNICAL PARAMETERS
| Operating voltage | 220-240V AC |
|---|---|
| Consumption | 36W – 4000K, 20W – 3000K and 6000K |
| Dimensions | 300 x 70 mm |
| IP Coverage | IP20 |
| Illumination angle | 120° |
| Chromaticity temperature | 3000K/4000K/6000K |
| Luminous flux | 2300lm – 4000K, 1200lm – 3000K and 6000K |
- Turn on
- Turn off
- Change colour temperature (-)
- Change colour temperature (+)
- Increase brightness
- Decrease brightness
- Brightness to 50%
- Brightness to 100%
- Color temperature change
- Switches off after 60 seconds
- Night mode (brightness 20%)
- Pairing button
INSTALLATION
Disconnect the power supply before installation.
- Insert the dowels into the pre-drilled holes.
- Thread the power cable through the holder and screw the holder in place.
- Thread the power cable through the hole in the luminaire.
- Screw the luminaire to the bracket.
- Connect the power cord to the terminal block and make sure the wiring is correct.
- Attach the front cover.
- Switch on the power supply.
Note: Use caution when removing the front cover. Press the cover down on one
side and lift it up on the other side to remove. You can use a blunt object
such as a knife.
Note: To pair the remote control with the light, switch the light off from the
mains for approx. 15sec and when the light comes back on, hold the centre
button with the WiFi symbol on the remote control (point 12 in the description
of the remote control).
After successful pairing, the light will flash twice.
The light source of this luminaire is non-replaceable, at the end of its
service life the entire luminaire must be replaced and disposed of in a
designated place. This product contains a light source that for design reasons
cannot be removed for verification and therefore the entire product is
considered a light source. The power cord cannot be replaced if damaged, the
unit must no longer be used.
We are not liable for any damage caused by improper use.
Producer:
Solight Holding, s.r.o., Na Brně 1972, Hradec
Králové 500 06, Česká republika.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>