2-in-1 Music & Lights Doorway Jumper™
Owner’s Manual Instructions

203121 2 in 1 Music and Light Doorway Jumper

IMPORTANT!
KEEP FOR FUTURE REFERENCE
Read all instructions and warnings before assembling and using your Doorway Jumper. Failure to follow each instruction can result in serious injury or death to your baby.
Instruction Manual available in additional languages at: www.infantino.com
This box contains: 1 Doorway Jumper (with clamp and spring housing); 1 music & lights toy
WARNING
TO PREVENT SERIOUS INJURY OR DEATH:
– Use your door jumper ONLY if the child meets ALL of the following conditions:

• At least 4 months of age
• Can sit upright unassisted
• Weighs less than 25 lbs. (11.3 kgs)

– Only use product on a recommended interior door frame. Baby’s toes must be able to touch floor when in use. See instructions for further details.
– WARNING! ENSURE THAT THE DOOR JUMPER IS POSITIONED IN THE CENTER OF THE DOOR FRAME. Pull downward on the product before placing child in the seat. If there is any movement in the door trim, do not use door jumper in that doorway.
– WARNING! DO NOT USE THE DOOR JUMPER AS A SWING!
– Do not allow child to spin around in product.
– Do not allow child to sleep in product.
– WARNING! NEVER LEAVE THE CHILD UNATTENDED! Always keep child in view while in the door jumper.
– Only use on a wall thickness between 4-6 in (10.2 – 15.2 cm) and with a trim thickness of at least 0.5 in (13mm). Trim must be flat at the top side and on both sides of the doorway.
– Do not secure the product to the door trim. The clamp must be positioned above the edge of the door trim.
– Ensure that the child is correctly and safely positioned in the door jumper before each use.
– Do not relocate or adjust height of door jumper while child is in the seat. – Only allow child to use the door jumper for short periods of time (Approximately 20 minute intervals).
– Ensure that the door cannot close on the door jumper.
– It can be dangerous to allow other children to play near or around the door jumper. Do not allow other children to hang or swing on door jumper.
– Do not add additional strings or straps to the product.
– Strings can cause strangulation! DO NOT place items with a string around child’s neck such as hood strings or pacifier cords. DO NOT suspend strings over product or attach strings to toys.
– Remove door jumper from doorway when not in use to prevent entanglement in straps.
– Do not give child food or drink while using the door jumper.
– Do not use door jumper near stairs.
IMPORTANT!
– Do not use if child is able to stand flat-footed with the doorway jumper adjusted to its highest position. Do not use if child’s toes cannot reach the floor in the lowest position. Follow height adjustment instructions provided in this manual.
– Adult assembly and installation required.
– Please read all instructions and warnings before assembling and using the door jumper.
– Inspect product, including the support frame and all components before each use. Never use this product if any parts are missing, damaged or broken. Contact Infantino for replacement parts and instructions if needed. Only use replacement parts and hardware that are supplied by the manufacturer.
– Make sure the product bounces freely, straps are not tangled, and the area around the unit free from obstructions.
– Take care when unpacking and assembling. Remove all plastic, thread, and/or wire packaging fasteners before giving any toy to a child.

Care Instructions:

Seat: Remove the fabric seat from the hanger, and remove the frame halves from the fabric seat. Hand or machine wash cold, gentle cycle. Tumble dry low or drip dry. Do not use bleach. Do not iron or dry clean. Make sure frame halves are securely fastened after
washing.
Plastic/Metal Parts and Toy: Surface clean only with a damp sponge or cloth. Do not immerse in water. Do not use harsh detergents or bleach.
Battery Installation: 3 x AA (1.5V) batteries (included)
Battery Replacement Instructions:

1. Loosen small screws and battery cover
2. Remove used batteries
3. Insert new batteries ensuring (+) positive end of batteries are placed as markings are shown.
4. Replace the battery cover and tighten. Do not over tighten. Make sure the battery cover is secure.

BATTERY WARNINGS:
Batteries should be replaced by an adult. Remove all batteries from toys which are not going to be used for an extended period of time to prevent battery leakage and product damage. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged (if removable). Rechargeable batteries are only to be charged under adult supervision. Different types of batteries or new and used batteries are not to be mixed. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply terminals are not to be short- circuited. Batteries must be recycled or disposed of properly.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio TV / technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-3(B)/NMB-3(B)

Contents/Parts List:

1. Clamp & Height Adjustment Assembly
2. Frame Half (with Electronic Toy Clip)
3. Frame Half
4. Fabric Seat and Webbing
5. Removable electronic toy

Doorway Frame Requirements:

Assembly

*When seat frame is pre-inserted, skip this step. IMPORTANT! After assembly and before each use, pull on the frame halves to make sure they are securely fastened.
Installing the batteries and attaching the electronic toy:

Assembly Continued

Adjusting the height of your doorway jumper:

IMPORTANT! NEVER adjust the door jumper’s height while baby is in the seat.
A. Door jumper’s height is perfect – baby’s toes touch floor
B. Door jumper’s height is too low
C. Door jumper’s height is too high
Clamping your door jumper: Removing the Electronic Toy: Removing fabric seat & webbing: Removing fabric seat & webbing, continued:

Play modes:

INFANTINO
SAN DIEGO, CA 92121 USA
www.infantino.com
? 1-800-840-4916
US.INFO@INFANTINO.COM
© 2023 BLUE BOX.
ALL RIGHTS RESERVED.
BEFORE USING THIS PRODUCT: Review and save the Instruction Manual for future reference.
Please call Infantino at 1-800-840-4916 (for US or Canada) with any questions or visit our website www.infantino.com.
MADE IN CHINA

203117 & 203121

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>