ideal lux 8I235547 Minor Pendant Light Installation Guide
- June 17, 2024
- ideal lux
Table of Contents
**Minor Round SP8
Suspension lamp
**
8I235547 Minor Pendant Light
GX53 max 8 x 9W / 220~240V 50/60Hz
– 8021696235547 NERO
FOLLOW THE ASSEMBLY INSTRUCTIONS BY READING THE NUMERICAL PROGRESSION. THE LIGHTING FITTING SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN.
THE SAFETY AND RELIABILITY ARE GUARANTEED ONLY WHEN INSTALLATION INSTRUCTIONS ARE PROPERLY FOLLOWED. PLEASE KEEP THIS INSTRUCTION SHEET FOR FUTURE REFERENCE.
This product is provided with a light source with efficiency energy class
of:
EAN
Energy Efficiency Class
8021696123936
F
ICON LEGEND
| Replaceable light source by an end-user.| |
---|---|---|---
| Replaceable LED light source by an end-user.| | Replaceable control gear by
an end-user.
| Replaceable light source by authorized personnel only.| | Replaceable light
source by authorized personnel only.
| Non-replaceable light source.
Upon end of life of the light source, the whole product will be replaced.| |
Upon end of life of the control gear, the whole product will be replaced.
REV 07/01/19
SAFETY INSTRUCTIONS
-
This fitting is produced and tested in accordance with the strictest European safety standards (EN 60.598- 1).
-
This fitting cannot be disposed of as household waste. For disposal information ask the local authorities about how to collect it.
-
As indicated by specific regulations, the lighting fitting should be installed by a qualified electrician.
-
If the external wire is damaged it has to be replaced exclusively by the manufacturer, distributor or by a qualified electrician.
-
Always isolate power before commencing installation, maintenance or repair.
-
The luminaire contains certain parts which can be very hot.
-
Each material requires specific mounting accessories. Use screws and wall plugs suitable for the material to which they are fastened. Those included may be unsuitable.
-
Always tighten the screws firmly to avoid contact problems.
-
This fitting should only be installed indoors.
-
Luminaires not suitable for recessed on normally flammable surfaces.
-
Luminaire not suitable for direct mounting on normal flammable surfaces.
-
This fitting is only suitable for fixing to the ceiling.
-
This fitting is only suitable for fixing to the wall.
-
The weight of the lamp has to be supported by the chain. Adjust the length of the electric wire so that it is longer than the chain.
-
Only use lamps which do not exceed the maximum specified wattage.
-
Always observe the minimum distance between the lamp and the surface being lit, as shown in the icon. The lamp can cause a fire if the minimum distance is not observed.
-
Auto-protected bulb. Only use bulbs marked with this symbol. Halogen bulbs get very hot. Wait until they cool down before replacing.
-
Cracked or broken safety glass has to be replaced immediately. Use only manufacturer approved parts complying with regulations.
-
Light source with not-substitutable light emitting diode (LED). Do not disassemble the product since the diodes can damage the eyes. Do not immerse in water. Wipe with a damp cloth. Do not use solvents or strong detergents.
-
This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
-
Class I Electrical safety guaranteed by the main insulation and an additional protective conductor (earthing) connected with the metal frame of the lamp. Earthing is obligatory.
-
Class Il Electrical safety guaranteed by the main insulation and a double or reinforced insulation.
Earthing not necessary. -
Class Ill Electrical safety guaranteed by very low power supply (less than 50 Volt). Earthing excluded.
-
Not protected.
-
Protected against solid objects greater than 50 mm.
-
Protected against solid objects greater than 12 mm.
-
Protected against solid objects greater than 2,5 mm.
-
Protected against solid objects greater than 1mm.
-
Dust protected.
-
Totally protected against dust infiltration.
-
Not protected.
-
Protected against vertically falling water drops.
-
Protected against water drops falling with a maximum angle of 15° to the vertical axis.
-
Protected against rain.
-
Protected against splashing water.
-
Protected against water jets.
-
Protected against strong water jets.
-
Protected against temporary immersion.
-
Protected against prolonged immersion.
-
Luminaire not suitable for covering with thermally insulating material.
-
Caution, risk of electric shock.
-
Do not stare at the operating light source.
IDEAL LUX s.r.
Via Taglio Destro 32
30035 Mirano (VE) Italy
www.ideal-lux.com
IDEAL LUX Warehouse
Via delle Industrie, 8/D
30036 Santa Maria di Sala (Venezia)
8.00 – 12.00 / 13.30 – 17.00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>