VALCOM VIP-415 IP Pendant Speakers User Manual

June 4, 2024
Valcom

VALCOM logo VIP-415 IP Pendant Speakers
**User Manual

**

 IP Pendant Speakers

These products are intended for use with a UL Listed power source marked “Class 2” or “LPS” rated 24VDC, or 48VDC (PoE).
PoE and all interconnected ITE are intended for intra-building.

FCC Information
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area may cause harmful interference in which case the user will be required to correct the interference at his own expense.

CAUTION

RISK OF ELECTRIC SHOCK DO NOT OPEN

CAUTION: To reduce the risk of electric shock, Do not remove the cover.
No user-serviceable parts inside.
Refer servicing to qualified service personnel.

**** This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.

****This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.

INTRODUCTION

VIP-415 is a Valcom Pendant Speaker.
It is available in white, black, and gray.

SPECIFICATIONS

Access Methods

  • PBX, FXO Port w/VIP-811
  • POTS telephone set w/VIP-811
  • PBX, FXS Port w/VIP-821
  • Valcom M Cast Page Group
  • SIP – enabled telephone system

Features

  • 802.3af compliant
  • High-Efficiency Class-D Amplifier
  • 14’ Ethernet Cable

Dimensions/Weight

  • 5.80” Dia. x 8.80” H
    (14.73cm Dia. x 22.35cm H)

  • 3.2 lbs. (1.45kg)

Environment

Temperature : 0 to +40° C
Humidity :0 to 85% non-precipitating
Nominal Power Requirements
Via 802.3af (PoE) Ethernet Switch Class 3

Precautionary Designations

  • WARNING -To Reduce The Risk Of Fire Or Electric Shock. Do Not Expose This Apparatus To Rain Or Moisture.

IMPORTANT SAFETY INFORMATION

  1. Read these instructions.
  2. Keep these instructions.
  3. Heed all warnings.
  4. Follow all instructions.
  5. Do not use this apparatus near water.
  6. Clean only with a dry cloth.
  7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
  8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
  9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade and the third prong are provided for your safety. If the provided plug does not fit into your outlet consult an electrician for the replacement of the obsolete outlet.
  10. Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
  11. Only use attachments/accessories specified by the manufacturer.
  12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
  13. Unplug this apparatus during lightning storms or when unused for a long period of time.
  14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way. Such as when the power supply cord or plug is damaged, liquid has been spilled, objects have fallen into the apparatus or the apparatus has been exposed to rain or moisture and does not operate normally or has been dropped.

INSTALLATION

Mounting
The VIP-415 Pendant Speaker is designed to be suspended from a ceiling using the enclosed chain. The chain is not attached to the ring at the top of the speaker to prevent damage to the speaker’s finish during shipping. To install the chain, open the link on the end of the chain and loop the link through the ring located on the top of the speaker and close the link. Make sure the chain is securely fastened to the ceiling.
NOTE : An additional 6 feet Length of chain is available. Order Part Number V-1093-BK
The area covered by a pendant speaker is determined by the suspended height of the speaker
The following chart shows the height and horizontal spacing (in feet) and the estimated coverage (in square feet).

Suspended Height 8 10 12 16 20
Horizontal Spacing 16 20 25 30 35
Approximate Coverage 250 350 500 800 1000

Network Connection

The VIP-415 has an approximately 14-foot Ethernet cable pre-wired at the factory and terminated with an RJ45 connector. Connect the cable to an Ethernet switch providing Power over Ethernet (PoE) meeting the 802.3af specification. If the switch does not provide power, a mid-span power injector may be used.VALCOM VIP-415 IP Pendant Speakers - FIGURE
1 Setup

Information specific to your application will need to be programmed into the VIP-415 using a computer. The PC used for programming should be connected to the same subnet as the VIP-415. Setup will be done using the IP Solutions Setup Tool.
Download the latest version of the free IP Solutions Setup Tool from the Valcom website at www.valcom.com/vipsetuptool.

TECHNICAL ASSISTANCE

Assistance in troubleshooting is available from the factory. Call 540-563-2000 and press 1 for Technical Support or via email at support@valcom.com.
When requesting assistance, you should include all available information. Information and troubleshooting procedures are available on the Valcom website at www.valcom.com.
Valcom equipment is not field repairable.
Valcom, Inc. maintains service facilities in Roanoke, VA. Should repairs be necessary, attach a tag to the unit clearly stating your company name, address, phone number, contact
person, and the nature of the problem. Send the unit to:

WARRANTY
Warranty information may be found on our website at www.valcom.com/warranty.

Valcom, Inc.
Repair & Return Dept.
5614 Hollins Road
Roanoke, Va. 24019-5056
947597

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals