YUNZII YZ87 Mechanical Keyboard User Manual

Table of Contents

YUNZII-YZ87-Mechanical-Keyboard-product

YUNZII-YZ87-Mechanical-Keyboard-fig-1

Use the charging cable provided with the product to connect the computer USB port or DC-5V charger to charge the keyboard.
During charging, observe the direction of the TYPE-C connector and insert it carefully into the charging seat of the keyboard.
When plugged in and powered on, the keyboard mode indicator will turn on red, and it will turn off automatically when fully charged.

Switch the mode button to Bluetooth Mode (BT). Then long press FN+Q=BT1, and the Q-key will blink cyan.
Press FN+W=BT2, and the W-key will blink pink.
Press FN+E=BT3, and the E-key will blink yellow.
When paired successfully, the Q/W/E key will stay on, and then restore to the last RGB mode.
The keyboard intelligently identifies the Bluetooth 5.0 standard communication in 3 channels.

FN+R

Switch the mode button to 2.4G Mode (2.4G). Then long press FN+R=2.4G, and the R-key will blink blue.
Plug the 2.4G dongle into the devices, then it will pair and install the compatible program automatically.
When paired successfully, the R-key will stay on, and then restore to the last RGB mode.

Use the attached TYPE-C cable to connect with the computer.
When the cable is plugged in, turn the keyboard mode switch to the middle wired mode position. At this time, the keyboard is automatically connected with the computer and can be used after installation.
This indicates that the keyboard is successfully connected with the computer TYPE-C cable and can be used.

FN AND LIGHT :

LIGHT COLOR (8 COLORS)

YUNZII-YZ87-Mechanical-Keyboard-fig-5

MAC FN DESCRIPTION

NOTES:

Autosleep Mode of YZ87: When the keyboard is still for 2-3 minutes, the keyboard will automatically turn off the backlight, and then press any key to wake the keyboard
Press FN+Backspace to turn ON/OFF the backlights, the keyboard can be reset by custom software.
For problem- Can’t be recognized by wireless connection: When the receiver of Y287 is plugged in but the computer cannot recognize it, it should be caused by poor contact.
For problem – When the backlight of the keyboard is dim or the product is used abnormally, it is because the battery is insuffcient. Charge the keyboard in time in case of out of power. When charging, connect the supplied TYPE-C cable with the keyboard and PC. The charging time will vary from the power of the charger.
If the product is not used for a long time, please turn the product mode switch to the wired mode, then charging.
For problem: The keyboard is stuck or suddenly does not work. It is caused by the interference of the same frequency signal in the environment, except for the low battery. In this case, the TYPE-C cable can be used to connect the computer to the wired mode. You can also switch between the Bluetooth channel and 2.4G channel again.

SPECIAL ATTENTION

If you want to disassemble this keyboard, pay attention to protecting the buckle and remove the switch button first. Otherwise, the switch handle will be broken when the cover is removed and the product will be damaged.
YUNZIl wireless products are all designed with built-inlithium batteries.YZ87 keyboard uses (5000 mAh Battery). Therefore, for user safety, the products can only be used indoors at room temperature. Please do not use them at high temperatures or near fire sources.
Don’t charge the keyboard by plug, power strip, and power bank. It can only been charged by the PC in wired mode.
Disposal of product damage: If the product is damaged and cannot be repaired, do not disassemble it or throw it into the fire to avoid accidental danger. It shall be sent to a professional waste disposal station or a special recycling box for disposal.
- If you have any product problems, please contact YUNZIl after-sales support team: support@yunzii.com