CHIEF SLB-281 Projector Interface Bracket Installation Guide
- June 17, 2024
- Chief
Table of Contents
CHIEF SLB-281 Projector Interface Bracket Installation Guide
INSTALLATION INSTRUCTIONS
SLB-281 and SLM-281 Interface Brackets are designed for use with Chief® Series
Projector Mounts. See the specific installation instructions provided with the
mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing,
immediately contact a Chief Customer Service representative
WARNING : IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING
SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by
manufacturer!
(1) Interface Bracket
(6) 10-24 Thumb Nuts
(1) All-Points Security Kit
(4) Screw, Phillips Pan Head, Machine, M5 x 20mm
(4) Washer, M5
(1) 5/32″ Security Hex Key
Only used when installing SLB interface brackets.
Installation Instructions
WARNING : OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND DAMAGE TO EQUIPMENT! DO NOT over tighten screws when installing interface brackets.
NOTE : Step 1 is only required when installing an SLB interface bracket. If an SLM bracket is being installed, proceed to step 2.
- Screw thumb screws onto 10-24 x 5/8″ Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
- Turn projector upside down on a flat surface.
- Place the interface bracket onto the bottom of the projector, aligning the mounting holes in the bracket with the threaded inserts in the bottom of the projector and ensuring that triangle in bracket points towards front of projector.
- Position M5 x 20mm mounting screws with M5 flat washers into the threaded inserts and four bracket side tabs. Tighten all fasteners at this time, securing the bracket to the projector
NOTE : Security screws can be substituted when mounting Interface bracket to projector by using the parts and installation instructions in the All- Points Security Kit
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
Milestone AV Technologies, and its affiliated corporations and subsidiaries
(collectively, “Milestone”), intend to make this manual accurate and complete.
However, Milestone makes
no claim that the information contained herein covers all details, conditions
or variations, nor does it provide for every possible contingency in
connection with the installation or use of this product. The information
contained in this document is subject to change without notice or obligation
of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no
responsibility for accuracy, completeness or sufficiency of the information
contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-002080 Rev00
©2010 Milestone AV Technologies,
a Duchesses Group Company
12/10
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>