BRAYER BR3210 Curling Tong Instruction Manual
- June 4, 2024
- BRAYER
Table of Contents
BR3210 Curling Tong
Instruction Manual
CURLING TONG BR3210
The curling tong is intended only for curling slightly wet and dry hair.
DESCRIPTION
1. Tip | 5. Light indicator |
---|---|
2. Operating surface | 6. Power switch «ON/OFF» |
3. Safety stand | 7. Handle |
4. Hair clamp handle | 8. Hanging loop |
ATTENTION!
- Do not use the unit near water in the bathrooms, showers, swimming pools, etc.
- After using the unit in a bathroom, unplug it and take the power plug out of the mains socket, as the proximity of water is dangerous even if the unit is switched off.
- For additional protection, it is reasonable to install a residual current device (RCD) with a nominal operating current not exceeding 30 mA into the mains of a bathroom.
To install it, contact an electrical technician.
SAFETY MEASURES AND OPERATION RECOMMENDATIONS
Read the operation instructions carefully before using the unit, after reading keep them for future reference.
-
Use the unit for its intended purpose only, as it is stated in this manual.
-
Mishandling the unit can lead to its breakage and cause harm to the user or damage to his/her property and it is not covered by warranty.
-
The curling tong is intended only for curling slightly wet and dry hair, do not use the unit to curl wet hair or synthetic wigs.
-
Make sure that the operating voltage of the unit indicated on the label corresponds to your home mains voltage.
-
Do not use the unit when you are drowsy.
-
Do not use the unit outdoors.
-
It is recommended not to use the unit during lightning storms.
-
Protect the unit from blows, drops, vibrations, and other mechanical stress.
-
Never leave the plugged-in curling tong unattended
-
Do not use the unit near heating appliances, heat sources, or open flames.
-
Do not use the unit in places where aerosols are used or sprayed, and in proximity to inflammable liquids.
-
Do not use the unit in proximity to the kitchen sink, bathrooms, swimming pools, or other containers filled with water.
-
Do not use the unit while taking a bath.
-
Do not hang and do not keep the unit in places where it can fall into a bath or a sink filled with water; do not immerse the unit body, power cord, or power plug into water or any other liquid.
-
If the unit is dropped into water, unplug it immediately, and only then you can take the unit out of the water.
-
Do not let the power cord touch hot surfaces and sharp edges of furniture.
-
Unplug the unit after usage or before cleaning.
When unplugging the unit hold the power plug and carefully remove it from the mains socket, do not pull the power cord — this can lead to its damage and cause a short circuit. -
Do not touch the unit body, the power cord, and the power plug with wet hands.
-
During the operation, hold the unit at the handle area only, do not touch the operating surface.
-
Avoid contact with hot surfaces with your face, neck, and other parts of your body.
The operating surface remains hot for some more time after the unit is unplugged. Be careful!
-
‘For children’s safety reasons do not leave polyethylene bags used as packaging unattended.
ATTENTION!
Do not allow children to play with polyethylene bags or packaging film. The danger of suffocation! -
The curling tong is not intended for usage by children.
-
Do not leave children unattended to prevent using the unit as a toy.
-
Do not allow children to touch the operating surface, unit body, power cord, or power plug during the operation of the unit.
-
Be especially careful if children or disabled persons are near the operating unit.
-
During the unit operation and breaks between operation cycles, place the unit out of reach of children.
-
The unit is not intended for usage by physically or mentally disabled persons (including children) or by persons lacking experience or knowledge if they are not under the supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
-
Regularly check the integrity of the power cord.
-
If the power cord is damaged, it should be replaced by the manufacturer, maintenance service, or similarly qualified personnel to avoid danger.
-
Do not repair the unit by yourself. Do not disassemble the unit by yourself, if any malfunction is detected, and after the unit was dropped, unplug it and apply to the service center.
-
To avoid damages, transport the unit in the original package.
-
Keep the unit in a dry cool place out of reach of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY, DO NOT USE THE UNIT FOR COMMERCIAL OR LABORATORY PURPOSES.
BEFORE THE FIRST USE
After unit transportation or storage at negative temperature, unpack it and wait for 3 hours before using.
- Unpack the unit and remove all the packaging materials.
- Keep the original package.
- Check the delivery set.
- Read the safety measures and operating recommendations.
- Examine the unit for damages, in case of damage do not plug it into the mains.
- Make sure that the specified specifications of the power supply voltage of the unit correspond to the specifications of your mains. When using the unit in the mains with 60 Hz frequency, the unit does not need any additional settings.
- Wipe the unit with a clean, slightly damp cloth to remove dust, and then wipe it dry.
- Unwind the power cord to its full length while using the unit.
USAGE
To achieve good results, wash your hair with shampoo, wipe it with a dry towel, dry it with a hairdryer and comb it. After that, you can curl your hair.
-
Divide the hair into locks 4-5 cm wide.
-
Put the unit on the safety stand (3) on a flat heat-resistant surface.
-
Insert the power plug into the main socket.
-
Switch the unit on by setting the power switch (6) to the position «ON», the light indicator (5) will light up.
-
Wait for some time until the operating surface (2) heats up.
-
Take a hair lock with the free hand.
-
Press the clamp handle (4) with the other hand, place the end of the hair lock on the operating surface (2), and release the clamp handle (4).
Holding the tip (1) and the handle (7), wind the lock around the operating surface (2). -
Wait for a while, then press the clamp handle (4) and release the hair lock.
-
Repeat this procedure on the rest of your hair.
-
Notes:
– when using the unit for the first time, a foreign smell from the heating element can appear — this is normal and it is not covered by warranty.
– avoid contact of hot surfaces of the unit with your face, neck, and other parts of your body during the unit operation.
– during breaks in operation, place the unit on the safety stand (3) on a flat heat-resistant surface.
– do not comb the hair right after curling it, let it cool down, hair spray should be applied after hair curling. -
After finishing the unit operation, switch the unit off by setting the power switch (6) to the «OFF» position, and unplug the unit.
-
Put the unit on the safety stand (3) on a flat heat-resistant surface and let it cool down completely.
CLEANING AND MAINTENANCE
- Before cleaning unplug the unit and let it cool down completely.
- Do not immerse the unit, power cord, and power plug in water or any other liquids.
- Do not use detergents, abrasives, or any solvents to clean the unit.
- Wipe the unit body with a soft, slightly damp cloth, and then wipe it dry.
STORAGE
- Let the unit cool down completely and clean it before taking it away for storage.
- Never mind the power cord around the unit as this can lead to its damage.
- A hanging loop (8) you can store the unit on is provided for ease of storage, given that in this position no water will get on the unit.
- Keep the unit in a dry cool place out of reach of children and people with disabilities.
DELIVERY SET
- Curling tong — 1 pc.
- Manual — 1 pc.
TECHNICAL SPECIFICATIONS
- Supply voltage: 110-240 V, ~ 50/60 Hz
- Rated input power: 80 W
- Operating surface diameter: 38 mm
ATTENTION!
Do not use the unit near water in the bathrooms, showers, swimming pools, etc.
RECYCLING
To prevent possible damage to the environment or harm to the health of people
by uncontrolled waste disposal, after the service life expiration of the unit
or the batteries (if included), do not discard them with usual household
waste, deliver the unit and the batteries to specialized centers for further
recycling.
The waste generated during the disposal of the unit is subject to mandatory
collection and consequent disposal in the prescribed manner.
For further information about recycling this product apply to a local
municipal administration, a disposal service, or to the shop where you
purchased this product.
The manufacturer reserves the right to change the appearance, design, and specifications not affecting the general operating principles of the unit, without prior notice.
The unit operating life is 3 years
The manufacturing date is specified in the serial number.
In case of any malfunctions promptly apply to the authorized service center.
The Unit Operating Life Is 3 Years.
RAYER is an
Austrian consumer electronics brand. The importer in Russia – “Grantel” LLC.
Hergestellt für «Ruste GmbH»,
Berggasse 18/18, 1090 Wien,
Osterreich
Produced for «Ruste GmbH»,
Berggasse 18/18, 1090 Vienna, Austria
т.: +7 (495) 297-50-20,
e-mail: info@brayer.su
Made in China
brayer.ru
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>