VAXCEL T0349 10 Inch Outland Steel Outdoor Pendant Light Installation Guide
- June 17, 2024
- VAXCEL
Table of Contents
VAXCEL T0349 10 Inch Outland Steel Outdoor Pendant Light
Product Information
Specifications
- Model: T0349, T0493
- Maximum Wattage: 60W
- Type of Bulb: Type A (not included)
- Warranty: 1 Year
FAQ
- Q: What is the warranty period for this product?
- A: The warranty period for this product is 1 year from the date of shipment.
- Q: What is not covered under the warranty?
- A: The warranty does not cover failure due to extreme acts of nature, unsuitable environmental conditions, operation in temperatures outside the specified range, or usage with improper power supply, power surges, or dips. Some corrosion is considered normal for coastal locations.
- Q: What should I do if I need to return a product under warranty?
- A: If you need to return a product under warranty, please follow the RMA (Return Merchandise Authorization) instructions provided by Vaxcel. The warranty is limited to the cost of the product and does not cover transportation, installation, or replacement costs.
WARNING: Turn off the main power at circuit breaker before installing fixture.
NOTE
- Before installing, consult local electrical codes for wiring and grounding requirements.
- Read and save these instructions.
Hardware Package And Spare Parts
Hardware Package (included)
Spare Parts List
The following parts are available for reorder if damaged or missing.
Installation Instructions
Installation Steps
Turn off the power at fuse or circuit box.
- Measure the desired length of the cord (a) from the canopy to the shade and leave additional 9″ cord (b) above the canopy (include the canopy). Then cut off the unnecessary cord. (See Fig.1)
- Adjust strain relief (F) at 9″ position from the top of the cord.
- Mark the 3″ cord (c) from the top of the cord (b). Use a knife to peel off the insulation of the cord (c) carefully to show the 3 inside wires.(See Fig.1)
- Caution: Cutting too deep may cut off three inside wires and destroy the insulation surface of the three inside wires.
- Peel off the 3 wires from the top about 3/8″ long (d) to expose the copper for wiring.
- Attach the mounting strap unit (A) to outlet box by using two mounting screws (B).
- Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
- Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
- Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
- Attach the fixture ground wire (green insulation) to the house ground wire with a wire connector (C). Carefully put all of the wires back into the outlet box.
- Attach the canopy to the mounting strap unit (A) by inserting the two fixture mounting screws into the open holes on the canopy, and secure it with two rubber pads (E) and two bolt nuts (D).
- Note: Adjust the strain relief can decrease or increase the length of cord exposing outside.
- Pull the cord (a) down slightly until the strain relief (F) touches the hex nut. Attach shade to the socket, then secure it with socket ring.
- Install the bulb (not included). See relamping label at socket area or packaging for maximum wattage allowed.
Turn on the power at fuse or circuit box.
Dimension
Warranty
1 Year Warranty
Vaxcel warrants all of our products against defects in workmanship and finishes for one year following the date of shipment.
Exclusions: This warranty does not include the failure of products from extreme acts of nature; environmental conditions not suited for the products intended use; operation in temperatures outside of the range specified in the instruction manual; usage with improper power supply, power surges or dips. For coastal locations, some corrosion is considered normal for the environment.
Vaxcel reserves the right to repair, replace or issue a credit for any properly installed product, provided it is returned per RMA instruction. This warranty is limited to the cost of the product only and does not extend to transportation, installation or replacement costs.
How can warranty service be obtained?