3SIXT 3S-0330 Trek Personal Bluetooth Speaker User Guide

June 17, 2024
3SIXT

3SIXT 3S-0330 Trek Personal Bluetooth Speaker

Important Safety Information

PLEASE READ BEFORE OPERATION

  1. Before recharging TREK through a wall outlet make sure wall outlet voltage is 5V.
  2. Make sure to use a standard USB 2.0 Charge & Sync Cable with the appropriate specifications – other cables may damage your smartphone, tablet or TREK.
  3. Do not drop, knock, disassemble or attempt to repair TREK.
  4. Do not immerse or put TREK in water and keep TREK in a dry place.
  5. Do not expose TREK to excessive heat including sunlight and fire.
  6. Do not use TREK near explosive gases or flammable materials.
  7. Do not burn or incinerate TREK.
  8. Do not expose TREK to harsh chemicals.
  9. Turning TREK’s volume up to the max shortens the life of TREK. It also may damage your hearing.
  10. Putting anything in TREK’s input or output ports, other than a standard USB 2.0 charge & sync cable will cause damage or short out TREK.
  11. When encountering any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage to the speaker or other components.
  12. The Bluetooth transmission range or connectivity could be affected by low battery power. In that case, recharge immediately.

CHARGING AND PAIRING

  1. Fully charge TREK for at least 2 hours through a wall outlet before first use (see step ➋).

To recharge TREK
Insert the supplied USB 2.0 cable (micro USB end a ) into TREK’s 5V input port b. Insert the USB end of cable c into the USB 2.0 port of your wall adaptor, laptop, or PC d.3SIXT-3S-0330-Trek-Personal-Bluetooth-Speaker-
fig-1

Pairing TREK for the first time with your device
Enable your device’s (eg. smartphone or tablet) Bluetooth. Hold down the Power Button f for 4 seconds to turn TREK on. TREK will automatically try to find your device. The LED e will flash blue and TREK should then appear in your device’s paired devices list. ‘Pair’ your device with TREK. TREK will then make another tone to confirm the pairing and the LED will stay blue to denote a connection. You are now free to play music & audio through TREK. Adjust the volume of TREK through your device’s volume settings or the buttons g on TREK (long press). For every pairing after your first, you only need to turn on your device’s Bluetooth, turn on TREK by holding down the Power Button e for 4 seconds and wait for the ‘pairing successful’ tone. To operate the speakerphone function, press h to pick up or hang up an incoming call.3SIXT-
3S-0330-Trek-Personal-Bluetooth-Speaker-fig-2

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals