ARTIS MCABLED03 LED Bathroom Mirror Installation Guide
- June 17, 2024
- artis
Table of Contents
ARTIS MCABLED03 LED Bathroom Mirror
Installation Manual for LED Bathroom Mirror
(Suitable for the touch switch and infrared sensor products installation by
hanging bar or hardy hole)
Notes:
To ensure the normal use of products, it is required set out wires as per the
regulations of IEE at the installation places. The products are only
applicable to be installed indoors. The installation must be executed by a
professional electrician, wrong installation may lead to product damage and
personal injury.
This product contains a light source of energy efficiency class âFâ
Installation
A/ Hanging bar Installation Manual (Instruction for LED bathroom mirror)
Horizontal the hanging bar
Make a mark on the wall through the hanging bar hole and drill the holes in
the mark with a drill
(Apply to the solid wall only)
Put the expansion plug into the hole in the wall, put the hanging bar against
the hole in the wall, and fix the hanging bar in the wall with screws
Measure the distance between these two hanging bar
According to the distance, place the shorter hanging bar in the lower centre of the longer hanging bar, then follow steps 2 and step 3.
Please cut off all the power before the connection
To connect as per the above photo
Hang up the mirror and shake left and right to see if it is stable.
Turn on the power
B/Hardy Holes Installation Manual (Instruction for LED bathroom mirror)
Please choose the portrait or landscape installation method first use the
measuring tape to measure to distance between the two holes
Horizontal-level ruler
Mark the distance between two holes in the wall with a pen
To use the drill to have the holes
Just apply it to the solid wall)
Use the hammer to strike the expansion rubber plug into the holes on the wall,
and then use the screwdriver to tighten the screws into the holes(exposure for
8-12mm)
Power Off
Please cut off all the power before the connection
To connect as per the above photo
Hang up the mirror and shake it left and right to see if it is stable
Turn on the power
Function usage
Please choose the below operation according to what product you buy: A, Touch switch.
- Touch switch holding to gradually dim.
- Touch switch press-hold colour change.
- Tap-tap touch colour change.
- The first short touch, turns on the light and demist pad; The second short touch, changes the colour temperature; The third short touch, turns off the light and demist pad, when the light is turned on; the first holding touch; the brightness of the light can be changed from 100% to 10% or 10% to100%, the second holding touch; the brightness of the light can be changed from 10% to 100% or 100% to 10%
Parts List
Tools
Installation tools ( as shown below)
Warm tips:
- Please do not use, it if the product has any broken.
- During operation, never put hard and sharp materials directly against the mirror surface. Otherwise, it may result in current leakage and even personal injury accidents.
- Never forget to turn off the power switch on storm days. Otherwise, lightning may damage the electric elements of the product.
- During normal operation, never forcibly pull out the power plug to stop the product. Otherwise, the electric elements of the product may be damaged.
- Please pull out the power plug if the product is not used for a long time.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>