ClearOne BMA 360 Conferencing Beamforming Microphone Array Installation Guide
- June 17, 2024
- ClearOne
Table of Contents
ClearOne BMA 360 Conferencing Beamforming Microphone Array
IMPORTANT INFORMATION
The method of attachment of the conduit box differs between a BMA CT or CTH,
and a BMA 360.
For the BMA CT or CTH, adhesive strips are used; for the BMA 360, screws are
used.
Important: Clear One recommends that you attach the conduit box before
you install the full unit in the ceiling grid.
For BMA CT or CTH
Step 1
Remove adhesive tape liner from bottom three surfaces of conduit box to expose
adhesive strips. This adhesive is rated for high temperatures.
Conduit Box Part Number:
910-3200-205-CB
Included Parts:
- Conduit box with 6 concentric 1/2” and 3/4” knockouts, with adhesive strips on edges (1)
- Conduit box lid (1)
- M4x8mm screws (4)
Step 2
To avoid prematurely engaging the adhesive while you align the open end of the
box to the BMA CT/CTH connectors, tilt the conduit box and slide it into
position against the self clinching nuts. Press the box into place.
Step 3
Remove the conduit box lid.
Attach conduit.
Route cables through desired knockouts.
Use the four M4x8mm screws to re-attach the conduit box lid.
For BMA 360
Step 1
Use the six M3x8mm screws to attach the conduit box to the back of the BMA
360.
Conduit Box Part Number:
910-3200-208-CB
Included Parts:
- Conduit box with 12 concentric 1/2” and 3/4” knockouts
- Conduit box lid (1)
- M4x8mm screws (4)
- M3x8mm screws (6)
Step 2
Remove the conduit box lid.
Attach conduit.
Route cables through desired knockouts.
Use the four M4x8mm screws to re-attach the conduit box lid.
SALES AND INQUIRIES
Headquarters
5225 Wiley Post Way Suite 500 Salt Lake City, UT 84116
US & Canada
Tel: 801.975.7200
Fax: 801.303.5711
International
Tel: +1.801.975.7200
global@clearone.com
Sales
Tel: 801.975.7200
sales@clearone.com
Tech Support
Tel: 801.974.3760
techsupport@clearone.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>