CRUX VIMLR-88 Land Rover Video in Motion Override Instruction Manual
- June 17, 2024
- CRUX
Table of Contents
CRUX VIMLR-88 Land Rover Video in Motion Override Instruction Manual
VERSION 1:
2005 – 2009 Land Rover Discovery (L319)
2005 – 2009 Range Rover Sport (L320)
2005 – 2009 Range Rover Vogue (L322)
VERSION 2:
2010 – 2011 Land Rover Discovery (L319)
2010 – 2011 Range Rover Sport (L320)
2010 – 2012 Range Rover Vogue L322)
Important Note:
This interface only supports the following radio types:
-Touch-Screen navigation Version 1 & Version 2.
We recommend reading this installation guide first before starting any work. Following these instructions from “Start” to” Finish” will ensure a smooth and hassle free installation. We offer telephone support M-F 9:00 AM – 5:00PM PDT at 1 855-822-1348. We are here to help.
PARTS INCLUDED:
(1) LR-88 Interface
(1) LR-88 Harness
(1) Instruction
PRECAUTIONS:
– Remove the negative side of the battery to avoid any short circuits durring
the installation.
– Do not install the interface near any major components or near the HVAC
system. This may cause damage or overheating to the vehicle.
– Do not disconnect the airbag connection behind the radio panel.
PRELIMINARY:
Please read the entire mannual before installing this interface.
Vehicle must be equipped with factory DVD changer.
This interface does not activate DVD reader.
SAFETY WARNING:
THIS INTERFACE IS DESIGNED TO ACTIVATE VIDEO IN-MOTION TO ALLOW THE PASSENER
ACCESS TO THE ADDRESS INPUT WHILE THE VEHICLE IS IN-MOTION. THIS INTERFACE MAY
CAUSE AN ERROR WHEN SERVICED AT THE OEM DEALER. BE AWARE THAT MOST DEALERS
WILL ATTEMPT TO VOID THE MANUFACTURERS WARANTY WHEN INSTALLING ANY AFTERMARKET
EQUIPMENT. IMPROPER USE OF THIS INTERFACE BY THE DRIVER MAY RESULT IN
CITATION. DRIVER MUST KEEP FULL ATTENTION ON THE ROAD AND RESPOSIBILITY ON THE
SAFETY OF HIS PASSENGERS.
INSTALLING THE INTERFACE:
1. Remove the factory radio to gain access to the factory connectors.
2. Make the T-Harness connections behind the factory radio. (if the
connectors do not match please contact tech support)
3. Test and make sure the Reverse gear triggers the interface and also test
the video in-motion while the car is rolling. (Navigation address input should
be active while rolling)
4. Make all other connections before re-installing the factory radio.
NON-PERMANENT VIDEO IN-MOTION:
If the customer wants the option to deactivate the video in-motion.
The installer can use the GREEN wire instead of the dip switch setting to
activate and deactivate the video in-motion.
This way the user can have access to the wire without having to get behind the
radio if eanting to deactivate.
INSTALLATION OVERVIEW
DIP SWITCH NUMBER 2 SETTING:
The interface works with vehicles with and without the factory rear-view
camera. Depending on the vehicle type you have, dip switch number 2 must be on
“ON” or “OFF
TROUBLE SHOOTING
1. No video display while driving.
– Make sure the dip switches are in the proper location.
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>