CRUX CSS-41 4 Input Automatic Video Switcher Instruction Manual
- June 3, 2024
- CRUX
Table of Contents
CRUX CSS-41 4 Input Automatic Video Switcher
PRODUCT FEATURES
- With 4 camera inputs.
- Automatic left and right turn signal triggering from an analog turn signal circuit.
- Automatic backup to front camera switching.
- Includes an RF remote control for force viewing of the cameras
NOTE: CR2016 battery required for RF remote. Battery must be purchased seperately.
PARTS INCLUDED
INSTALLATION INSTRUCTIONS
- Plug in the video camera RCAs to the corresponding RCA inputs on the CSS-41.
- Each camera input of the CSS-41 has a +12V power for the camera. Make sure to use these for the unit to function properly.
- Connect the red wire on the Video output RCA of the CSS-41 to the Reverse Gear Signal input of the aftermarket camera.
- Tap the turn signal input wires of the CSS-41 to the corresponding analog turn signal power wire.
- Tap power and ground to the CSS-41.
WIRING DIAGRAM
TESTING FOR FUNCTIONALITY
- Turn ignition to ACC and turn on the radio.
- Use the RF remote control and test each camera.
- Use the turn signals to turn on the left and right cameras
- Put the gear in reverse to check the backup camera image.
- Put the gear to drive and the front camera should turn on for 7 seconds. To turn off this feature, press and hold the middle button “M” on the RF remote control. The LED will flash 2 times indicating that it has programmed the auto front camera turn on after a reverse process. Restart the CSS-41 to recognize this mode. Repeat the steps to turn the feature back on.
Crux Interfacing Solutions Chatsworth, CA 91311
phone: 818-609-9299
fax: 818-996-8188
www.cruxinterfacing.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>