CRUX SWR-100 Universal Steering Wheel Control Retention Interface Instruction Manual
- June 17, 2024
- CRUX
Table of Contents
SWR-100
Universal Steering Wheel Control Retention Interface
PRODUCT FEATURES:
– Retains Steering Wheel Controls via built-in, pre-programmed interface.
– Provides +12 volt accessory output.
– Auto detect on CAN Bus vehicles.
– Retains VR Command (Voice Recognition) function on select OEM steering wheel
controls to activate CarPlay and Android Auto compatible devices.
– Works on the new generation Sony Radio with CarPlay function.
PARTS INCLUDED:
SUPPORTED RADIOS:
| Alpine | Clarion | Fahrenheit | JVC | Pioneer | Sony |
|---|---|---|---|---|---|
| Boss | Dual | Jensen | Kenwood | Power Acoustik | Soundstream |
INSTALLATION DIAGRAM:
*For vehicles
with analog SWC, connect the Red/White wire to ACC to power the module.
For vehicle specific wiring diagram and connection, please visit:
www.cruxinterfacing.com/wiring or
click on the QR code.
http://www.cruxinterfacing.com/wiring/
SWC CONNECTION:
For aftermarket radios with a 3.5mm jack for the SWC, use the SWC cable below.
(Old Sony, New Sony (with CarPlay/Android Auto), Pioneer, Jensen, Dual,
Fahrenheit, New Soundstream)
For GM vehicles with LIN Bus, tap the GREEN (LIN Bus) wire to the
GREEN/BLACK wire on the factory SWC. 
For radios with wires (2 or 3 wire) connections
for SWC, use the female 3.5mm adapter.
(Boss, Power Acoustik, select Sounstream)
For Kenwood and JVC radios with a BLUE/YELLOW
wire connection for SWC, tap to the BLUE/YELLOW wire of the SWC
adapter..
http://www.cruxinterfacing.com
Crux Interfacing Solutions
6860 Canby Ave., Suite 116, Reseda, CA 91335
phone: 818-609-9299
fax: 818-996-8188
www.cruxinterfacing.com
rev.042318
https://manual-hub.com/