VISUAL COMFORT KW 5037 Utopia Mini Pendant Instruction Manual
- June 4, 2024
- VISUAL COMFORT
Table of Contents
Utopia Mini Pendant
Item # KW 5037
ASSEMBLY INSTRUCTIONS
NOTICE:
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
TOOLS REQUIRED (NOT INCLUDED):
| Phillips Screwdriver | Slotted Screwdriver |
|---|---|
| Wire Cutters | Wire Strippers |
-
Carefully remove all parts from the box. Place on a clean, soft surface.
-
Remove mounting plate (B) from the canopy (F) by removing the collar ring (G).
-
Install mounting plate (B) to the junction box and secure with mounting screws (D).
-
Feed electrical and ground wires through bottom rod (J) and connect to fixture body (K). Repeat for middle rod (I), connecting to the bottom rod (J).
-
Continue feeding the electrical wire through the collar ring (G), canopy (F), and top rod (H).
-
Holding fixture upright, slide collar ring (G) and canopy (F) down rods, and rest on the fixture (K). Then connect top rod (H) to middle rod (I).
NOTE : Slide components down slowly to avoid damage. -
Hang fixture swivel ball (L) to the center of mounting plate (B) and secure with set screw (C) using provided wrench.
-
Cut excess wires, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8”.
-
Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
NOTE : It is imperative that the fixture is grounded. -
Connect driver (E) input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A).
NOTICE :
This light fixture should be installed in accordance with all applicable,
local installation codes, and by a person familiar with the construction and
operation of it, as well as the hazards involved. Inspect items and contents
carefully. If any damage or defect is found, do not install. Retain all
packaging material until installation is complete and approved.
-
Connect driver (E) input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
CAUTION : Do not reverse the hot and neutral connection
Connect fixture neutral wire (black) to driver (E) output wire (black) using wire nut (A). -
Connect fixture hot wire (red) to the driver (E) output wire (red) using wire nut (A).
CAUTION : Do not reverse the hot and neutral connections. -
Make sure all wire connections are tight, then carefully tuck them into the junction box.
-
Insert driver (E) into the mounting plate bracket.
-
Install canopy (F) to mounting plate (B) and secure with collar ring (G). Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Care Instructions:
Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>