ASAKUKI ROCK Mini Premium Essential Oil Diffuser User Guide
- June 17, 2024
- ASAKUKI
Table of Contents
ASAKUKI ROCK Mini Premium Essential Oil Diffuser
Clean the water tank every 3 days
INSTRUCTION
- Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
- Do not permit the area around the diffuser to become damp. If dampness occurs, turn the output of the oil diffuser down. If the oil diffuser output volume cannot be turned down, use the oil diffuser intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to become damp.
- Unplug the appliance during filling and cleaning.
- Never leave water in the reservoir when the appliance is not in use.
- Empty and clean the oil diffuser before storage. Clean the oil diffuser before next use.
Warning : Micro-organisms that may be present in the water or in the environment where the appliance is used or stored, can grow in the water reservoir and be blown in the air causing very serious health risks when the water is not renewed and the tank is not cleaned properly every 3 days.
Package
Notice:
The power adapter, remote control and USB cable are included in the water
tank.
Button Control Guide
LIGHT Button
- After the USB cable is connected, press the “LIGHT” button once to turn on the light. The LED light color will cycle from dim to bright gradually.
- Continue pressing will fix the color at a bright or dim status.
- Long press about 3 seconds to turn off the light.
MIST Button
- Short press the “MIST” button once to turn on the spray, and the spray time will be set to continuous on.
- Continue to press to set spray time to intermittent model 2H/ 4H and turn off.
Clean & Maintenance
Please clean the diffuser per week as follows:
- Unplug the diffuser and pour out the remaining water from “DRAIN SIDE”
- Add 2-3 drops of vinegar to 100ML warm water (up to 70°C/158°F).
- Leave diffuser for 5 minutes and gently shake and pour out water.
- Wipe the diffuser with a dry soft cloth.
- Avoid removing the cover while the product is in operation to prevent condensation from entering the inside of the machine base via the button or fan.
Remote Control Guide
-
ON/OFF
First press: Turn on the mist and set at continuous misting mode.
Second press: Turn off the mist and light. -
Intermittent
When the diffuser is turned on, press to set to intermittent mist mode. It will mist for 10 seconds stop for 10 seconds and cycle. -
Continuous
When the diffuser is turned on, press to set to continuous mist mode. -
Timing
When the diffuser is turned on:
First press: Set at 2-hour mist mode.
Second press: Set at 4-hour mist mode. -
Big/Small
(Big/Small mist mode can only be set by remote control)
Press to adjust the mist density, one beep sound for strong mist, two beep sounds for weak mist. -
Light
One press: Turn on the light and 7 color cycles. Next presses will fix each color at dim or bright mode and turn off the light.
Notice
- When filling water, do not exceed the max line marked on water tank.
- Please power off diffuser first before adding water.
- The diffuser will beep two times and turn off automatically when water is used up.
- Please use pure natural essential oils.
- If the diffuser is leaking for any reason, please unplug the unit and pour out the remaining water. Shake the diffuser gently to drain water inside, then dry for more than 24 hours.
- If the machine switches off automatically after pressing the “Big/Small” button on the remote control, this may be due to water entering the base, but the internal base plate has a waterproof paint that will not be damaged, so simply pour out the water and wait for the machine to dry before using it normally.
TROUBLESHOOTING
No power| The power cord is loose or the cord is defective| Check the cord connection and try a new USB cord
No mist comes out
| Water runs out| Add water to the water tank
Water scales and essential oil particles clog the ultrasonic sheet
| Wash the water tank with a warm mixture of 10% vinegar and 90% water. Then clean the round ultrasonic sheet inside the water tank with a dry cloth
Mist is too weak
| The tank is overfilling with water| Water should never exceed the max line
on the water tank
Air inlet is blocked| Always place a diffuser on a flat table
If your problem is not listed, please contact Customer Support.
Email us at support@asakuki.com
Specifications
Tank Capacity | 300ml |
---|---|
Working Mode | ON/INT/2H/4H |
LED Colors | 7 Bright, 7 Dim |
Ultrasonic Frequency | 2.4MHz |
Product Dimensions | 12412486mm |
Product Weight | 335g |
Power | 5W |
Power Input | 5V/1A |
Product Materials | PP/ABS |
Accessories | USB Cable, Remote Control, User Manual |
Brand: ASAKUKI
Product Name : Essential Oil Diffuser
Model Number : AD002
WEEE-Reg. -Nr: DE: DE 41980660 FR: FR031399 05UERI
Manufacture : Chongqing ChuangHong Dian Zi Shang Wu You Xian GongSi
Address : 1 zhuang 11-3, jin kai da dao 1228 hao, bei bu xin qu,
Chongqing, 401120, China
UK REP
UK Responsible Person: JunBright Ltd
Address : 51 Chalton Street London, England, NW1 1HY
Email : yldyx112@outlook.com
EC REP
EU Responsible Person: C&E Connection E-Commerce (DE) GmbH
Address: Zum Linnegraben 20, 65933, Frankfurt am Main, Germany
Email : info@ce-connection.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>