Fellowes 425Ci 4x30mm Shredding Machines Instruction Manual
- June 17, 2024
- Fellowes
Table of Contents
425Ci 4x30mm Shredding Machines
POWERSHRED
A25Ci/4251/485Ci/4851
THE WORLD’S TOUGHEST SHREDDERS”
Please read these instructions before use.
Do not discard: keep for future reference.
Quality Office Products Since 1917
KEY
A SafeSensee Technology
B. Paper entry
C. (D, credit cord and junk mail entry
D. Door
E Casters
E. See safety insirucions
6. Disconnedt power switch
H. Oil reservoir
425G and 485G only
1. Oil drain plug (inside) 425€ and 485Gionly
J. Basket
K. Accessory tray
L. Conirol panel
- Sheet capacity indicator
- Low of indicator (red) 425G and 485G onlly
- Bin full (red)
- SafeSense® (yellow)
- Remove paper (red)
- Door open (red)
- Sraight feed (red)
- Auto button
- Reverse
- ON/OFF
- Forward
CAPABILITIES
Will shred: Paper, 132 column continuous form, credit cards, CD/DVDs, staples,
paper dips and junk mail
Will not shred: Adhesive labels, transparencies, newspaper, cardboard, large
paper dips, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
Cross-Cut (425, 485Ci).
5/32in.x 1-1/8in. (3.9mm x 30mm)
Strip-Cut (425i, 485i)..
1/4in. (5.8mm)
Maxiwom:
Shoets per poss (Cross-OUt)………………………….Oe
Sheets por poss (SUip-OUt) …………………………………..3B”
ODsAlars pet………………………………..1
Paper entry width (4B5G, 485i)……………………… 16 int. (407 mmm)
Paper entry width (425G, 425i) ……………………….. EZ iat (305mm)
*9.5°x11°, 2b, (759) poper of 120%, 60 Hz, 12Amps; heavier paper, humidity or other than roled voltage may reduce capacity. Recommended daily usage rates: 10,000 sheets per doy, 500 credit cords; 50 Co.
Fellowes Sole Sense” shredders ore designed 19 be operated in office
environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrons
Cobias) ond 49 – BOX rederive humidity
WARNING :
IMPORTANT SAFETY INSTRUCTIONS
Read Before Using!
-
Keep away from children and pets. Keep hands away from paper entry. Abways serf to off or unplug when not in use.
-
Keep foreign objects — gloves, jewelry, do thing, hair, etc. — away from shredder openings. If object enters fop opening, switch fo Reverse (<) 1o back out object.
-
Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.
-
Do ot use if damaged or deceive . Do nof disassemble shredder.
Do ot place near or over heat source or water. -
Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operatingshredders.
-
This shredder has o Disconnect Power Switch (G) thot must be in the ON (1) position fo operate shredder. In case of emergency, move switch fo OFF (0) position.
-
This action will stop shredder immediately.
-
Avoid touching exposed cutting blades under shredder head. Use only designated eniry for (Ds/cards. Keep fingers away from (D entry.
-
Do not put foreign objects in paper entry. Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, fransformers, or extension cords should not be used with this product.
-
FIRE HAZARD — Do NOT shred greeting cards with sound chips or batteries.
-
For indoor use only.
-
Unplug shredder before dleaning or servicing.
BASIC SHREDDING OPERATION
Plug in and put disconnect power switching ON 1) position
Press (cb) ON/OFF fo adivate (blue)
Feed paper into paperentry and release
Feed CD, credit card or junk mail into designated entry and release
Set to Off ( ) or shredder will automatically go into sleep mode after 2 minutes of inactivity
ADVANCED PRODUCT FEATURES
Jam Proof System Eliminates paper jams and powers through tough jobs.
Auto Oil Lubricates the cutters automatically to enhance performance and
extend shredder life.
Patented SafeSense ® Technology Automatically stops when hands touch the paper
opening.
Energy Saving System
Reduces energy consumption by up to 70%. Compared to conventional shredders
during normal usage.
**JAM PROOF SYSTEM OPERATION***
Eliminates paper jams and powers through tough jobs.
STRAIGHT FEED
If Straight Feed indicator illuminates, remove paper and feed straight into
shredder.
AUTO OIL™ OPERATION
Lubricates the cutters automatically to enhance performance and extend
shredder life (Auto oil system is only included on cross-cut models – 425Ci
and 485Ci.)
Before using, fill oil reservoir with 12 oz. (355 ml.) of Fellowes shredder oil
Press the auto and forward buttons at the same time for 3 seconds to manually oil shredder
Low oil indicator will signal when your reservoir needs refilling
To maintain shredder performance, refill oil reservoir with up to 12 oz. (355 ml.) of shredder oil (Fellowes #35250)
Once refilled, automatic oiling will resume
SAFESENSE ® TECHNOLOGY OPERATION
Automatically stops when hands touch the paper opening.
SLEEP MODE OPERATION
Energy saving feature shuts down the shredder after 2 minutes of inactivity
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However,
on rare occasions, the sensors may become blocked by paper dust causing the
motor to run even if there is no paper present. (Note: two paper detection
sensors are located in the center of the paper entry.)
AUTO OIL TM
Automatically oils the cutters to enhance performance and extend shredder
life.
(Auto oil system is only included on cross-cut models – 425Ci and 485Ci)
REFILLING THE OIL
Low oil indicator will signal when your reservoir needs refilling
To maintain shredder performance, refill oil reservoir with up to 12 oz. (355 ml.) of shredder oil (Fellowes 35250)
Once refilled, automatic oiling will resume
- All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and couldul timately stop running. We recommend that you re fill the Auto Oil TM reservoir as instructed for optimum performance.
- If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain, remove plug and let oil drain out. Replace plug.
TROUBLESHOOTING
Low Oil Indictor: When illuminated, the shredder is out of oil and needs to be
refilled. See the Produc Maintenance section for refill instructions.
For optimum performance, use Fellowes oil (35250). *Auto Oil™ i only featured
on cross cut models — 425Ci and 485Ci.
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs
fo be emptied. Use Fellowes waste bag 3605801.
SafeSense® Indicator: If hands are foo close to the paper entry, the
SafeSense® indicator will iluminate and the shredder wil stop shredding. If
SafeSense® is adtive for 3 seconds, the shredder will automatically turn off
and the user must press the power button on the conirol panel to resume
shredding.
Remove Paper Indicator: When illuminated, press reverse (<) and remove paper.
Reduce paper quantity fo an acceptable amount and reefed into paper entry.
Door Open Indicator: The shredder will nof run if the cabinet door is open.
When illuminated, close the door to resume shredding.
Straight Feed Indicator: When illuminated, remove paper and feed sfraight info
paper entry.
**JAM PROOF SYSTEM***
Eliminates paper jams and powers through tough jobs.
DISABLING THE FEATURE
Should you choose fo disable the system, press and hold the auto and reverse (<) butions ot the same fime
Once disabled, the blue Auto fight is no longer illuminated (To re-engage, repeat step 1)
Shredding can confinue vith the system disabled; however, a paper jom may occur with foo many sheets and Remove Paper icon will illuminate
1f jam occurs, press and hold forward ( » ) button until the document is completely through the shredder
If not dleared, press reverse ( ) briefly (repeat steps 4 and 5 until shredded)
If steps 4 and 5 do not dear jam, reverse paper all the way out, remove several sheers and refeed
LIMITED PRODUCT WARRANTY
Limited W arranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of defects in material and workmanship and provides service and support for 2 years from the date of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material and workmanship for the lifetime of the shredder. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, atFellowes’optionandexpense,ofthedefectivepart.Thiswarrantydoesnotapplyincasesofabuse, mishandling, failure to comply with product usage standards, shredder operation using an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country charge the consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide except where ifferent limitations, restrictions, or conditions may be required hy local law. For more details or to obtain service under this warranty, please contact us or your dealer.
Questions or Concerns?
www.fellowes.com
Troubleshooting
Registration
Manuals
Customer Service & Support
Troubleshooting
Replacement parts
General questions
Canada +1-800-665-4339
Mexico +1-800-234-1185
United States +1-800-955-0959
©2011 Fellowes, Inc. Part No. 406778
1789 Norwood Avenue, tasea, in6ts 6o143-1095 • usA·
630-893-1600
www.fellowes.com
Documents / Resources
|
Fellowes 425Ci 4x30mm Shredding
Machines
[pdf] Instruction Manual
425Ci 4x30mm Shredding Machines, 425Ci, 4x30mm Shredding Machines, Shredding
Machines, Machines
---|---