DYNOJET PC6-20045 Power Commander 6 for 2001 Suzuki Hayabusa Installation Guide
- June 4, 2024
- Dynojet
Table of Contents
POWER COMMANDER 6
Installation Guide for PC6-20045
Model Coverage: 2001 Suzuki Hayabusa
PC6-20045 Power Commander 6 for 2001 Suzuki Hayabusa
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS
Map
(Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can
switch on the fl y between these two base maps when you hook up a switch to the
MAP inputs. You can use any open/close type switch. The polarity of the wires
is not important.
Shifter
(Input 1 or 2) Used for clutch-less full-throttle upshifts. Insert the wires
from the Dynojet quick shifter into either Input 1 or Input 2. The polarity of
the wires is not important. Set to Input 2 by default.
Speed
If your application has a speed sensor then you can tap into the signal side
of the sensor and run a wire into this input. This will allow you to calculate
gear position in the Control Center Software. Once gear position is set up
you can alter your map based on gear position and setup gear-dependent kill
times when using a quick shifter.
Analog
This input is for a 0-5v signal such as engine temp, boost, etc. Once this
input is established you can alter your fuel curve based on this input in the
Power Core software.
Launch
You can connect a wire to either Input 1 or Input 2 and then the other end to
a switch. This switch when engaged (continuity) will only allow the RPM to be
raised to a certain limit (set in the software). When released, you will have
full RPM.
WIRE CONNECTIONS
To input wires into the PC6 first remove the rubber plug on the backside of the
unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PC6
until it stops and then tightens the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them
easier.
INSTALLING THE POWER COMMANDER 6
-
Remove the main seat and the passenger seat.
-
Hold the front of the fuel tank up using the prop rod located in the trunk area.
-
Locate the connector from the main wiring harness to the injector rail and unplug this connector. This connector is WHITE in color.
-
Plug the pair of connectors from the PC6 in-line with the stock connectors.
-
Route the PC6 wiring along the inside of the frame towards the battery.
-
Secure the ground wire of the PC6 to the negative (-) side of the battery.
-
Using the supplied Velcro, secure the PC6 module in the rear section of the trunk.
Clean both surfaces with the supplied alcohol swab prior to applying the Velcro adhesive. -
Bolt the fuel tank back into place and reinstall the seats.
Download the latest map files from our website at dynojet.com/tunes.
Optional Inputs:
Speed input – PINK wire on BLACK 3-pin connector from the speed sensor on the
countershaft sprocket cover (BLACK/RED, BLACK/WHITE, PINK).
Temperature input – BLACK/BLUE wire of temp the sensor at the rear of the
engine.
12v source for Autotune – BROWN wire of taillight connector.
2191 MENDENHALL DRIVE, NORTH LAS VEGAS,
NV 89081
– 800-992-4993
– DYNOJET.COM
© 2001-2022 DYNOJET RESEARCH ALL RIGHTS RESERVED
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>