Get Packed Packmate R-Wrapper Mobile Pallet Wrapping Trolley User Guide
- June 16, 2024
- Get Packed
Table of Contents
Get Packed Packmate R-Wrapper Mobile Pallet Wrapping Trolley
ASSEMBLY INSTRUCTIONS
Step 1 During assembly, leave within open cardboard carton to avoid
scratches. R-Wrapper frame must lay down as in the way it is carried with
single ‘carriage tube’ UP as illustrated.
Step 2 Remove smaller cardboard wrap from Carriage and slide carriage
right, towards pulley-end of frame.
Step 3 Remove and unwrap base and wheels from carton and keep nearby the
‘wooden shipping-board’ end.
Step 4 To remove the shipping board and while supporting the carriage
tube weight: Undo two 13mm bolts with a spanner and the 6mm socket head bolt
with an allen-key. Swap board with base and wheels and fasten bolts through
base into frame tube ends. Tighten 6mm ‘Allen-key’ with spanner or tube
for leverage. Check frame tubes are parallel before tightening 13mm bolts
firmly when R-Wrapper is upright.
Step 5 Slide Carriage toward base before standing R-Wrapper up on wheels
to avoid carriage dropping down to the base
Step 6 Ensure lift rope is sitting in pulleys and not snagged around
pulleys, carriage or any control handles then check operation.
See INSTRUCTIONS FOR USE sheet for correct operation
STEP 1: Wheel the r-Wrapper to the pallet TO do the job!
PACKMATE R-WRAPPER, MOBILE, ERGONOMIC PALLET WRAPPING. DESIGNED & MADE IN
AUSTRALIA. SEE.
CUSTOMER SERVICES
029452-3566
[email protected]