CIAYS CTSG01 Height Safety Dog Gate Stairs Instruction Manual

June 16, 2024
CIAYS

CIAYS CTSG01 Height Safety Dog Gate Stairs Instruction Manual

COMPONENTS

Find your model to see what components are included.

Model Supplied Parts Extensions List Gate Max Size
Main Gate Tension Bolt Screws Wall Cup
Battery 3.9in (10cm) 7.9in (20cm) 11.9in (30cm)
a b c d
CISGO6W xl x4 x6
CISGO8W xl x4 x6
CTSGO1/CISGO1 xl x4 x6
CTSGO2/CISGO2 /CISGO2B1 x1 x4 x6
CTSGO3/CISGO3 x1 x4 x6
CTSGO4 x1 x4 x6

WARNING

  • To prevent serious injury or death, securely install the gate or enclosure and use according to manufacturer’s instructions.
  • Stop using when a child can climb over, enclosure or dislodge the gate.
  • This product will not necessarily prevent all accidents.
  • Never leave child unattended.
  • Use only with the locking mechanism securely engaged.
  • Intended for use with children from 6 months through 24 months of age.
  • Stop using gate if any parts are missing or become damaged.
  • Children may die or be seriously injured if gates are not securely installed.
  • ALWAYS install and use gates as directed using all required parts.
  • Periodically check all fasteners to be sure they are tight and secure.
  • Adult Assembly Required.
  • The surfaces that the gate is to fixed to must be suitable for the purpose and must be structurally sound.
  • Indor use only, and not to be exposed to outdoor elements.
  • Install this gate away from heaters and other sources of heat.
  • STOP using when a child can climb over or dislodge the gate.

WARNING

  1. To help with installation, DO NOT CUT OFF THE  CABLE TIE until the installation is completed!
  2. The door gap is NOT a defect! It will be shortened to 0.08in (0.2cm) after installation.

Before installation, there will be a gap between the gate latch and the frame which is NOT a defect and it is NOT bent. This gap will disappear after installation, and then you can cut off the tightening cable tie.

Bottom of the stairs


Must be placed before the lowest stairs
Top of the stairs


Must be placed on the highest stairs and drilled for installation
If used in any scenarios below the following aspects need to be noted
Bottom of the stairs:  must be placed before the lowest stairs
Top of the stairs:  must be placed on the highest stairs and drilled for installation

INSTALLATION GUIDE

METHOD A:
(Follow STEP 1-2-3-4-6)


METHOD B:
(Follow STEP 1-2-3-4-5-6)

STEP 1. Measure the width of the doorways.
Following the below extension combination suggestions to install the gate and extensions.

COMBINATION WIDTH (MIN-MAX)
a 29.5-33.5in(75-85cm)

CISGO6W

Fits 29,5-33.5in(75-85cm)

COMBINATION WIDTH (MIN-MAX)

a
a+b1| 29,.5-33.5in(75-85cm)
33.5-37.4in(85-95cm)

CISGO8W

COMBINATION WIDTH (MIN-MAX)

a
a+b1
a+b1+b1| 29.5-33.5in(75-85cem)
33.5-37.4in(85-95cm)
37,4-41,3in(95-105cm)

CTSGO1/CISGO1

COMBINATION WIDTH (MIN-MAX)

a
a+b1
a+b2
a+b1+b2| 29,5-33,5in(75-85cm)
33.5-37.4in(85-95cm)
37,4-41.3in(95-105cm)
41.3-45.3ind105-115cm)

CTSGO2/CISGO2/CISGO2B1

COMBINATION WIDTH (MIN-MAX)

a
a+b1
a+b2
a+b1+b2
a+b2+b2
a+b1+b2+b2| 29.5-33.5in(75-85cm)
33.5-37.4in(85-95cm)
37.4-41.3in(95-105cm)
41.3-45.3ind105-115cm)
45.3-49.2in(115-125cm)
49.2-53.1ind125-135cm)

CTSGO3/CISGO3

COMBINATION WIDTH (MIN-MAX)

a
a+b1
a+b2
a+b3
a+b1+b2
a+b1+b3
a+b2+b3
a+b1+b2+b3| 29.5-33.5in(75-85cm)
33.5-37.4in(85-95cm)
37.4-41.3in(95-105cm)
41.3-45.3indl05-115cm)
41.3-45.3indl05-115cm)
45.3-49.2in(15-125cm)
49.2-53.1in(125-135cm)
53.1-57.0in(135-145¢em)

CTSGO4

Step 2.
Insert 4 bolts into 4 corners of the gate/extension.

Expanding the gap between the rubber foot and the adjustment wheel. In order for the gate to function properly.
It is recommended that the gate gap between the gate locks is O.O8in (0.2cm).

Step 3.
Pre-assemble the gate, and locate four points for hole drilling. Hold the wall cup in position and mark the center with a pencil
Position your gate in the center of the opening on the floor. DO NOT allow a gap of more than (2 inch) 5cm between the gate and the Wall.

Step 4.
Cover the wall cup to the bolts. Tighten the wheel inward by hand, Do not over tighten.

Step 5.
Drill holes for the 4 marked positions, then put wall anchors and use screws and the wall cup.

STEP 6. OPERATING THE GATE

A. To Open the Gate

  1. Cut off the cable tie and check if the gate is firmly attached.
  2. Pull the button back with your thumb.
  3. Lift the door panel to open in either direction.

B. To Close the Gate

NOTE:

  • If the gate is too difficult to latch or latch, adjust the tightness of 4 adjustment bolts until the gate can be unlatch and latch smoothly.
  • If the gate lock is too difficult to unlatch, slightly loosen the adjustment wheels.
  • If the gate lock is too loose to latch, slightly tighten the adjustment wheels.

TURN ON THE  ALARM

  1. Unscrew the bolt with a self-supplied Phillips screw- driver to detach the cover.
  2. Put two AAA batteries into the battery compartment.
    1. Reattach the cover by tightening the bolt with the Phillips screwdriver.
  3. Turn on the button of the alarm, the alarm rings for 10 seconds once the gate is unlatched.

Thank you for choosing this product! We strive to provide you with the best quality products and services in the industry. Should you have any issues, please don’t hesitate to contact us at
Questions or Problems?
support@ciays.com
Latest Information and More.
@CiaysOffcial

https://www.facebook.com/CiaysOffcial

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals