Lecoo C8 Smart Sunglasses User Guide

June 16, 2024
Lecoo

Standard configuration

Lecoo C8 Smart Sunglasses -

Appearance

Lecoo C8 Smart Sunglasses - Touch area

Instructions

  1. Power on/off & Bluetooth pairing

•  Power on/off
•  Long press the MFB button for 2 seconds to turn on/off, the blue LED flashes when turning on, and the voice prompt “power on” ,the red light flashes when turning off, and the voice prompt “power off”
•  Bluetooth pairing
•  Power on enter the pairing mode,and turn on the Bluetooth of the device to be connected, search for “Lecoo-C8″ for pairing, and the blue light will flash per 3 seconds after the pairing is successful. (voice prompt “Lian ji cheng gong”) It will automatically
enter the pairing mode after disconnecting
•  Automatically connect back to the last connected Bluetooth device after power on, Automatic shutdown without Bluetooth connection in 5 minutes

  1. Audio mode
    •  Volume setting
    •  One click the touch area to be volume +, there will be a prompt sound when the volume is adjusted to the maximum
    •  Long press the touch area for volume –
    •  Voice assistant
    •  Double-click the MFB button
    •  Call mode
    •  One click the MFB button to answer phone call
    •   One click the touch area to reject phone call
    •  One click the MFB button to hang up the current call

  2. Charging mode
    •  Charging time about 1.5 hours, low battery alarm voice prompt “battery low”
    •  Low battery alarm interval is 60 seconds, red light flashes, The red LED is on when charging, and theblue LED is on when it is full
    •  Unable turning on while charging

Warning message
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance  could void the user’s authority to operate theequipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit difierent from that to which the receiver is connected.
  •  Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be u sed in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals