Klipsch Flexus SUB 100 Authentic American Audio Instruction Manual
- June 16, 2024
- Klipsch
Table of Contents
- Klipsch Flexus SUB 100 Authentic American Audio Instruction Manual
- ADD TO YOUR SYSTEM
- IMPORTANT SAFETY INSTRUCTIONS
- FCC AND CANADA EMC COMPLIANCE INFORMATION
- FCC RF Radiation Exposure Statement
- INSIDE
- SYSTEM SETUP
- ADDITIONAL PERIPHERALS
- SOUND BAR CONTROLS
- SUBWOOFER PLACEMENT
- SUBWOOFER RECONNECT
- ADJUSTING BASS LEVEL
- SURROUND LEVEL ADJUSTMENT
- NIGHT MODE
- FACTORY RESET
- LED DISPLAY
- Read More About This Manual & Download PDF:
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Klipsch Flexus SUB 100 Authentic American Audio Instruction Manual
KLIPSCH CONNECT APP
**** APPLICATION KLIPSCH CONNECT • APLICACIÓN KLIPSCH CONNECT • KLIPSCH CONNECT APP • APP KLIPSCH CONNECT • APLICATIVO KLIPSCH CONNECT KLIPSCH CONNECT应用 • KLIPSCH CONNECTアプリ
- Download the Klipsch Connect app
- **Follow the instructions
**
ADD TO YOUR SYSTEM
Flexus Sound System is built to grow with you. Add up to two wireless surround
speakers and a second wireless subwoofer to create a home theater.
For more information, please visit:
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions
- Keep these instructions
- Heed all warnings
- Follow all instructions
- Do not use this apparatus near water
- Clean only with dry
- Do not block any ventilation openings. Install in accordance with the manufacture’s
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding plug. A polarized plug has two blades with one wider than the other. A grounding plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete
- Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at the point where they exit from the
- Only use attachments/accessories specified by the
- Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart or rack is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- Unplug the apparatus during lightning storms or when unused for long periods of time. Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus has been exposed to rain or moisture, does notoperate normally, or has been dropped.
FCC AND CANADA EMC COMPLIANCE INFORMATION
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. -
Any Changes or modifi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving
- Increase the separation between the equipment and
- Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is
- Consult the dealer or an experienced radio/TV technician for
FCC RF Radiation Exposure Statement
- This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
- This transmitter must not be colocated or operating in conjunction with any other antenna or
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
CE RF Radiation Exposure Statement
This device can be operated in at least one Member State without infringing
applicable requirements on the use of radio spectrum.
This equipment complies with EU radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20 cm
between the radiator and your body.
This device complies with Industry Canada’s licence-exempt RSSs. Operation is
subject tothe following two conditions:
- This device may not cause interference; and
- This device must accept any interference, including interference that may cause undesired operation of the device
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
- l’appareil ne doit pas produire de brouillage, et
- l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le “
Radio Frequency (RF) Exposure Informatio
The radiated output power of the Wireless Device is below the Industry Canada
(IC) radio frequency exposure limits. The Wireless Device should be used in
such a manner such that the potential for human contact during normal
operation is minimized.
This device has also been evaluated and shown compliant with the IC RF
Exposure limits under mobile exposure conditions. (antennas are greater than
20cm from a person’s body).
for each off mode, standby mode (or another condition which does not exceed
the applicable power consumption requirements for off mode or standby mode)
and networked standby into which the equipment is switched by the power
management function or similar function:
- the power consumption expressed in watts rounded to the first decimal place;
- the period after which the equipment reaches automatically standby mode, off mode or networked standby in minutes and rounded to the nearest minute;
DC OUT 1——— USB Type-C(5V/0.5A)
INSIDE
CONTENU • CONTENIDO • INHALT • CONTENUTO • CONTEÚDO
Subwoofer
Caisson de
graves
Subwoofer
Subwoofer
Subwoofer
Subwoofer
SYSTEM SETUP
CONTENU • CONTENIDO • INHALT • CONTENUTO • CONTEÚDO •
ADDITIONAL PERIPHERALS
CONTENU • CONTENIDO • INHALT • CONTENUTO • CONTEÚDO
SOUND BAR CONTROLS
BARRE DE SON • BARRA DE SONIDO • SOUND BAR • SOUND BAR • BARRA SONORA
SUBWOOFER PLACEMENT
POSITIONNEMENT DU CAISSON DE GRAVES • UBICACIÓN DEL SUBWOOFER • SUBWOOFER- PLATZIERUNG • COLLOCAZIONE DEL SUBWOOFER POSIÇÃO DO SUBWOOFER •
Corner placement will increase the amount of bass output, while placing the
subwoofer along the middle of a wall, or out in the room will decrease the
amount of bass output.
Une position en coin augmentera le volume des graves, tandis qu’une position
au milieu d’un mur, ou au milieu de la pièce, réduira le volume des graves.
SUBWOOFER RECONNECT
RECONNECTER • RECONECTAR • ERNEUT VERBINDEN • RICONNESSIONE • RECONECTAR
ADJUSTING BASS LEVEL
AJUSTEMENT DU NIVEAU DU CAISSON DE GRAVES • AJUSTE DEL VOLUMEN DEL SUBWOOFER • SUBWOOFER-LAUTSTÄRKE EINSTELLEN • REGOLAZIONE DEL LIVELLO DEL SUBWOOFER • AJUSTE DO NÍVEL DO SUBWOOFER
SURROUND LEVEL ADJUSTMENT
NIVEAU DU SURROUND – AJUSTEMENT RAPIDE • VOLUMEN DE SURROUND – AJUSTE RÁPIDO • SURROUND-LAUTSTÄRKE – SCHNELLEINSTELLUNG • REGOLAZIONE RAPIDA DEL LIVELLO DEL SUBWOOFER • NÍVEL SURROUND – AJUSTE RÁPIDO
NIGHT MODE
MODE NUIT • MODALIDAD NOCTURNA • NACHTMODUS • MODALITÀ ORE NOTTURNE • MODO NOTURNO
FACTORY RESET
RÉINITIALISATION • RESTABLECIMIENTO DE FÁBRICA • RÜCKSETZUNG AUF WERKSEINSTELLUNG • RIPRISTINO IMPOSTAZIONI DI FABBRICA RESTABELECIMENTO DAS CONFIGURAÇÕES DE FÁBRICA
LED DISPLAY
DISPLAY | BAR STATUS |
---|
OTHER
| PAIRING| Peripheral pairing
PAIR FAILED| Subwoofer/surrounds failed to pair
SUB PAIRED| Subwoofer paired
“The Bluetooth ® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by Klipsch Group, Inc. is under license. Other trademarks and trade names are those of their respective owners.”
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>