PurSteam PS 650 Purfect Portable Steamer Instruction Manual

PurSteam PS 650 Purfect Portable Steamer Instruction Manual

Precautions

• Before using this product, please read all of the instructions carefully and save them for future reference.
• To reduce the risk of electric shock, do not immerse the appliance in water or other liquids.
• This steamer produces high temperature steam therefore care must be taken to avoid scalding.
• Electrical outlet voltage must correspond to that of the appliance. Connecting to incorrect voltage may cause damage to the unit and will void your warranty.
• Do not operate appliance with a damaged cord, or if the appliance has been dropped or damaged. To reduce the risk of electric shock, do not disassemble or attempt to repair the appliance, take it to a qualified service person for examination and repair. Incorrect reassembly or repair could cause a risk of fire, electric shock, or injury to persons when the appliance is used.
• We do not recommend using an extension cord, but if it is necessary, an (ampere rating of the appliance) ampere rated cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or tripped over.
• Keep away from children and pets. People with physical, sensory or mental capabilities or lack of knowledge and experience, must be under supervision when using the appliance.
• Do not place hands or fingers near the steam while using the unit. Steam is very hot and can cause burns.
• NEVER POINT THE NOZZLE TO YOUR FACE OR ANY PART OF YOUR SKIN. THIS CAN CAUSE SCALDING AND SERIOUS INJURIES.
• Make sure the steamer is NOT plugged in before filling the tank with water and has cooled down completely before cleaning it.
• Never operate the steamer without water.
• For indoor and household use only. Do not operate the steamer with wet hands or on wet surfaces.
• Be sure to gently remove the plug from the outlet. Allow approximately 10 minutes for the steamer to cool down completely before cleaning or removing any accessories & attachments.
• After the steamer has cooled down, store it in a cool, dry area.
• Do not point the nozzle directly at wooden areas or walls. High temperature steam may cause damage or discoloration of such surface.
• Fill the water tank with water ONLY. Do not add any other liquids or chemicals to the reservoir as it may damage the unit or cause an injury.
• To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by holding it away from body and operating steam button.
• Use appliance only for its intended use.
• Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
• Do not allow cord to touch hot surfaces. Let appliance cool completely before putting away. Loop cord loosely around appliance when storing.
• Always disconnect appliance from electrical outlet when filling with water or emptying, and when not in use.
• Close supervision is necessary for any appliance being used by or near children.
• Do not leave appliance unattended while connected.
• Burns could occur from touching hot metal parts, hot water, or steam. Use care when you turn a steam appliance upside down — there may be hot water in the reservoir.
• To reduce the likelihood of circuit overload, do not operate another high wattage appliance on the same circuit.
• To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

Initial Use

• After opening the package, make sure accessories are not damaged or broken.
• Do not share the outlet with any other high-powered electrical appliances.
• When using the steamer for the first time, release the steam for a few minutes on old fabric or cloth as there might be residue or odors from the manufacturing process or transportation.

Garment steamer parts

Installation And Use

1. Pull out the water tank. Open the pressure cap and fill the tank with water. Fill water reservoir to maximum fill line. Do – not overfill.
   

2. After filling the reservoir with water, place the water tank back into the unit.
   

3. Attach accessories as needed. Make sure accesso- ries are attached before the unit is plugged into a power outlet.
   

4. Connect the power plug to an outlet. The steamer will start preheating automatically and the heating indicator light will keep on until the steamer completes preheating in 1 minute.
   

5. After the steamer is heated, you can start to use the steam button:

   • a. By Pressing the button Continuously. This will produce the steam on demand, when you want to stop steaming just release the button;

   • b. By pushing the switch down.
     This will lock the button and the steam will come out continously. To stop the steaming, push the switch up and release the button.
     

6. When the steamer is in standby mode, keep pressing the start button and the steam will be released.

7. When the steamer is in locked mode, steam will continue to come out without pressing the start button.

Steaming your clothes

1. Check the fabric before steaming a complete item on a small area to ensure it will not be damaged during (S steaming. Use the brush for softer E and more delicate fabrics like silk.
   

2. Begin by pointing the nozzle towards the wrinkled area of the fabric you want to steam. Move the steamer slowly up and down holding it in an upright position.
   

3. Hold the nozzle at least 1 to 2 inches away from the fabric. Do not hold the steam in one spot for long periods of time, this can soak the fabric and cause possible damage.

4. Check the water level in the tank, If the buzzing sound becomes louder and steam is not coming out, add water as needed. Make sure to un-plug steamer before adding water.

5. Allow the steamer to cool down for four to five minutes before refilling the water reservoir with the proper amount of water.

CAUTION : Do not direct steam at A e people or animals or use the steamer on garments while they are being worn directly.

After use

1. Turn the steamer off by unplugging the unit from the power outlet.

2. Wait for the steamer to cool down for approximately 10 minutes. Empty the excess water out of the reservoir and [ leave the water tank empty and dry.
   
   CAUTION: The water inside the reservoir remains hot after the unit is turned off, empty with caution as this can cause scalding.

3. After emptying any excess water out of the tank, clean the unit and store it in an upright (vertical) position in a cool and dry place for future use.

Care, Cleaning and Storage

• Remove the brush from the unit and clean it with warm water.
• Do not use coarse fabrics to clean the steamer. This may cause scratches and damage to the unit.
• Do not place the unit under running water or immerse it into water or other liquids.
• Be careful not to drop the unit. This can cause serious damage.
• Do not attempt to disassemble any accessories or appliances.
• Avoid exposing the steamer to direct sunlight or wet areas. Do not leave the steamer outdoors.

1-Year Limited Warranty

This product is warranted to be free from defects in material and workmanship under normal use and service for 1 year from the date of original purchase with receipt. The manufacturer’s obligation shall be limited to repairing or replacing, any part of the product that is defective. Such warranty shall not apply to damages resulting from accidents, abuse or misuse.

37 East 18th, Floor 7, New York, NY 10003
**   Telephone: 855-530-6800
E-mail: support@pursteam.us
Web:** www.pursteam.us

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>