Goldair GBH100 Ceramic Pull Cord Bathroom Heater Instructions
- June 16, 2024
- GOLDAIR
Table of Contents
GBH100 Ceramic Pull Cord Bathroom Heater
RETROFIT/REPLACEMENT
INSTRUCTION
If you are swapping out your existing 3508W or GBH100/250/300 heater, please follow steps below:
-
Ensure that backing plate has been installed correctly during initial install – the required clearances are detailed on the READ ME FIRST SHEET and again in the instruction manual.
-
Remove current heater from mounting base by inserting a blade screwdriver into the hole located below the middle of the outlet grill.
-
Rotate the screwdriver until the clip releases.
-
While holding the heater, gently push up with the screwdriver, sliding the heater off the wall mounting base.
-
GBH450/550 can then be slipped straight onto the existing wall mounting base. You should hear a click as the heater locks into place.
-
Your new bathroom heater is now ready for use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>