PHILIPS OCC0100A/02 BP Sensor WH Instruction Manual
- June 12, 2024
- Philips
Table of Contents
PHILIPS OCC0100A/02 BP Sensor WH Instruction Manual
DIMENSIONS
TOOLS REQUIRED
INSTALLATION INSTRUCTION
Note
Battery replacement must be done by skilled or instructed person.
Caution
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 200 mm between the radiator and a human body.
RF Exposure Information
This device meets the EU requirements (2014/53/EU) on the limitation of
exposure of the general public to electromagnetic fields by way of health
protection. The device complies with RF specifications when the device used at
200 mm from your body.
ISED Statement:
This device contains licence-exempt transmitter(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, (2) this device must accept any interference, including
interference that may cause undesired operation of the device
2023 Signify Holding. All rights reserved. Specifications are subject to change without notice. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. All other trademarks are owned by Signify Holding or their respective owners.
UK importer address:
Signify Commercial UK Limited
3, Guildford Business Park, GU2 8XG
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>