OUKITEL C23 Pro Most Affordable Cutting-Edge Phone User Manual
- June 10, 2024
- OUKITEL
Table of Contents
C23 Pro Most Affordable Cutting-Edge Phone
Product Information
The C23Pro is a smartphone manufactured by SHENZHEN YUNJI INTELLIGENT TECHNOLOGY CO.,LTD. It features a 6.528HD+ incell water drop screen with Android 10 operating system. The phone is powered by 4x-Cortex-A53 2.0 GHz +4x-Cortex-A53 1.5 GHz GE 8320 650MHz processor and comes with 2/3/4GB RAM and 16/32/64GB internal storage. The phone has a 5000mAh battery and is equipped with a 13M AF +2M+2M+0.3M rear camera and an 8M front camera.
The phone supports dual SIM (Nano/TF Card) and has the following network
bands:
2G: B2/3/5/8, 3G: B1/2/5/8 (European version),
3G: B2/4/5 (American version),
4G: FDD B1/3/5/7/8/20 TDD B38/40 (European version), and
4G: B2/4/5/7/12/13/17/28cA+B (American version). The phone supports
multiple audio formats such as AAC/AAC+/AMR/AWB/MP3/WMA/VORBIS/FLAC/APE and
weighs 215g.
Product Usage Instructions
To use the C23Pro smartphone, follow the below instructions:
- Charge the phone using the USB port and connect it to a power source.
- Press and hold the power key to turn on the phone.
- Follow the on-screen instructions to set up the phone.
- To insert the SIM card, locate the SIM tray on the side of the phone and use the provided tool to open it. Insert the SIM card into the tray and close it.
- To insert a TF card, locate the TF card slot on the side of the phone and use the provided tool to open it. Insert the TF card into the slot and close it.
- To take photos or videos, open the camera app and select the desired camera mode. Use the on-screen controls to adjust settings and capture photos or videos.
- To listen to audio, connect a pair of earphones to the 3.5mm audio jack or use Bluetooth to connect to a wireless device.
- Use the volume buttons to adjust the volume and the power key to turn off/on the phone or lock/unlock the screen.
Overview
FRONT
BACK
Accessories
Battery
C23 Pro includes an internal battery. You can track your battery status with the icon showed on the top right of the screen. When overheated by microwave ovens, stoves, radiators, batteries may explode.
Warning
- Use only OUKITEL-approved batteries specifically designed for your phone. Incompatible batteries can cause serious injuries or damage to your phone.
- Never place batteries or phones on or in heating devices, such as microwave ovens, stoves, or radiators. Batteries may explode when overheated.
Basic parameters
- Display:
- 6.528″HD+ incell water drop screen
- Operating system:
- Android 10
- Processor:
- 4x-Cortex-A53 2.0 GHz +4x-Cortex-A53 1.5 GHz
- GPU:
- GE 8320 650MHz
- RAM:
- 2/3/4GB
- ROM:
- 16/32/64GB
- Battery:
- 5000mAh
Camera
Connection (1/0)
- 2G: B2/3/5/8
- 3G: B1/2/5/8 (European version) 3G:B2/4/5 (American version)
- 4G: FDD B1/3/5/7/8/20 TDD B38/40(European version)
- 4G: B2/4/5/7/12/13/17/28（A+B） (American version)
- SIM Card Slot: Dual SIM, Nano
- FM: 87.5 MHz-108 MHz
Other Features
- Video: AVI, MP4, WMV, MKV, MOV, ASF, FLV
- Audio: AAC/AAC+/AMR/AWB/MP3/WMA/VORBIS/FLAC/APE
- Image: JPEG, BMP, GIF,PNG
Dimensions Package contents
Comes with the Google app and Google Chrome Android is a trademark of Google
LLC
MANUFACTURER NAME: SHENZHEN YUNJI INTELLIGENT TECHNOLOGY CO.,LTD
MANUFACTURER ADDRESS: A-SIDE A2 BUILDING 2/F EN ET NEW INDUSTRIAL
PARK,N0.20
DAFU INDUSTRIAL ZONE, AOBEI COMMUNITY, GUANLAN, LONGHUA NEW DISTRICT,SHENZHEN
CHINA
Manufacturer’s Name: SHENZHEN YUNJI INTELLIGENT TECHNOLOGY CO.,LTD
Smart Phone
Model number: C23Pro
Operating Temperature: -10° C to 40° C
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a minimum separation distance of 0mm must be maintained between the user’s body and the handset, including the antenna. Third-party belt-clips, holsters, and similar accessories used by this device should not contain any metallic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna. This device in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. All essential radio test suites have been carried out.
- Use careful with the earphone maybe possible excessive sound pressure from earphones and headphones can cause hearing loss
- CAUTION : RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
- The product shall only be connected to a USB interface of version USB 2.0
- Adapter shall be installed near the equipment and shall be easily accessible.
- The plug considered as disconnect device of adapter
- The device complies with RF specifications when the device used at 0mm form your body
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Mobile Phone meets the government’s requirements for exposure to radio
waves. The guidelines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health.
requirements, use accessories that maintain a 10mm separation distance between
the user’s body and the back of the handset. The use of belt clips, holsters
and similar accessories should not contain metallic components in its
assembly. The use of accessories that do not satisfy these requirements may
not comply with FCC RF exposure requirements, and should be avoided.
Body-worn Operation
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 10mm must be
maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do not
meet these requirements may not comply with RF exposure requirements and
should be avoided. Use only the supplied or an approved antenna.
FCC ID: 2ANMU-C23Pro
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>