CALI RAISED MOTO 127051-1B Road Glide LP6 Kit Instruction Manual
- June 16, 2024
- CALI RAISED MOTO
Table of Contents
CALI RAISED MOTO 127051-1B Road Glide LP6 Kit
Kit Contains
- 1- Rear Bracket …….127051-1B
- 1- Left LP6 Mount …127051-2B
- 1- Right LP6 Mount.127051-3B
- 1- Front Tin …………..127057-4B
- 1- Shield Seal ………127051-Seal
- 1- Hardware Kit …….127051-H
Thanks for purchasing our Road Glide LP6 Kit. After using other kits &
components available, we decided to create a more “installer-friendly” version
that allowed access to bolts that, in many bikes, are hidden and VERY time-
consuming to install.
NOTE: Amps and/or other after-market add-ons may require modification to
the fins on the back of the light housing. We do this from time to time
ourselves and it has not created any issues.
INSTALLATION
-
Remove your Road Glide front fairing. Keep track of your factory hardware as you will re-use factory bolts to hold down the rear plate of your new kit.
-
Remove your headlight assembly and unplug your light, leaving the harness inside. Put this in a safe place with any parts in case you need them later.
-
Open your new Road Glide Kit 127051.
-
Carefully remove front Shield/Tin and set aside being very careful not to twist bend or sit anything on this piece.
-
Locate the “Rear Plate” and remove the packaging. (See illustration #1 below)
-
Install this rear plate using the factory screws that held your headlight assembly.
Important: Install all 4 screws before tightening any. Once all 4 screws are in it is ok to torque down TOP 2 ONLY, by hand or using T-Handle fallen. Leave the bottom 2 factory bolts just snug as they will come off at the end to be put back through the top Shield.
-
Next, open both LP6 Brackets. One left and one right. Mount your LP6 lights to these in the order you want them to show. Note: There is a Left and a Right. Leave the front 7/16 nut a bit loose so you can adjust later. See Illustrations 3 and 4 below.
-
Open the small hardware bag full of 6mm socket heads. Apply a drop of BLUE thread Locker to the thread on each small sock head. If you can’t get any thread locker, then use black RTV silicone adhesive.
-
Install both lights. Do not tighten any one socket head until all 4 are in on each side.
-
Next, check the lights to insure they work. BEFORE YOU PUT YOUR FRONT SHIELD/ TIN on.. We suggest you roll your bike in front of a wall about 15 feet away and look to see that the bright ball of light is in a sensible location.
-
Take the Shield and locate the rubber seal supplied about 12” long. Install the seal on the top lip with your hands.
-
Once you feel the lights are good, and you’re ready to install front shield, remove the lower 2 factory bolts that hold the light assembly on and place the shield around your lights, lining up the lower holes. Install those 2 bolts but do not tighten yet.
-
Lastly, install the top centre and last remaining 6mm socket head in the centre of the shield.
Follow and Tag Us! @cali_raised_moto Share some pics of your finished Install
For Questions on this kit or other kits, we sell…. Email us at
info@Caliraisedmoto.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>