DYNOJET 2006-2007 Kawasaki ZX-10R Power Commander 6 Installation Guide
- June 4, 2024
- Dynojet
Table of Contents
DYNOJET 2006-2007 Kawasaki ZX-10R Power Commander 6
INPUT ACCESSORY GUIDE
OPTIONAL ACCESSORY INPUTS
- Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these towable maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important.
- Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts. Insert the wires from the Dynode quick shifter into either Input 1 or Input 2. The polarity of the wires is not important. Set to Input 2 by default.
- Speed If your application has a speed sensor then you can tap into the signal side of the sensor and run a wire into this input. This will allow you to calculate gear position in the Control Center Software. Once gear position is setup you can alter your map based on gear position and setup gear dependent kill times when using a quick shifter.
- Analog This input is for a 0-5v signal such as engine temp, boost, etc. Once this input is established you can alter your fuel curve based on this input in the Power Core software.
- Launch You can connect a wire to either Input 1 or Input 2 and then the other end to a switch. This switch when engaged
(continuity) will only allow the RPM to be raised to a certain limit (set in the software). When released, you will have full RPM.
WIRE CONNECTIONS
To input wires into the PC6 first remove the rubber plug on the backside of the
unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PC6
until it stops and then tighten the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them easier.
INSTALLING THE POWER COMMANDER 6
-
Remove the main seat and the passenger seat.
-
Place the PC6 module in the tail section and route the wiring harness on the inside of the tail section towards the front of the bike.
-
Unbolt the front of the fuel tank and prop it up.
-
Route the PC6 harness down the left hand side of the bike going beneath the fuel tank bracket.
-
Locate and unplug the sub-harness connector for the bike’s fuel rail.
This is a 16-pin BROWN connector on the right hand side of the bike under the fuel tank and behind the engine.
-
Plug the pair of PC6 connectors in-line of the stock connectors.
-
Secure the PC6 ground wire with the ring lug to the negative terminal of the bike’s battery.
-
Using the supplied Velcro, secure the PC6 module in the tail section.
Clean both surfaces with the supplied alcohol swab prior to applying the Velcro adhesive. -
Secure the front of the fuel tank and reinstall the seats.
Download the latest map fi les from our web site at dynojet.com/tunes.
Optional Inputs:
- Speed – BLUE/YELLOW wire. Senor is located on the left hand side of the engine case in front of the counter-shaft sprocket.
- Engine Temperature – BLUE/WHITE wire on the GREY 10-pin connector under the fuel tank.
- 12v Source for Autotuned – RED wire of the taillight connector.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>