Nilight 10038W LED Light Bar Wiring Harness Kit User Manual
- June 16, 2024
- Nilight
Table of Contents
Nilight 10038W LED Light Bar Wiring Harness Kit User Manual
Installation:
- Connect light bar wires to wiring harness terminals respectively, black to black, red to red.
- Run rocker switch wires through switch cutout/opening in the dash. Connect the 5-pin rocker switch with wiring harness. 2 methods of connection, please refer to the instruction on the below.
- Connect wiring harness to the car battery. Red wire (+) with fuse to positive, black wire(-) to negative.
- Turn on the power and press switch on/off to test the light.
Caution:
- The operating voltage is 12V DC. 16AWG: Max. Wattage 180W/ 14AWG: Max. Wattage 300W /12AWG: Max. Wattage 450W
- Please make sure all the exposed wires were securely wrapped by electrical insulating tape to prevent short circuit.
- Please strictly follow the instructions to avoid any hazards. If you do not feel comfortable with the installation we recommend having a professional to install or install under his guidance.
Last Step: Complete the 5-Pin Rocker Switch Connection.
Note: The above 5-Pin rocker switch connection is not completed yet,
please select either one of the following methods to complete:
Wiring Method:
A : Connect red jumper wire from 2 to 6 (Lower indicator light will turn
on when the key is timed on)
Wiring Method:
B :Connect white jumper wire from 3 to 6 Lower indicator light will turn
on only when the switch is turned to the on position)
Need Help?
If you’re having an issue with the product or need technical support, Nilight
team is always here to help and make sure your 100% satisfaction.
nilight.com/pages/contact
Scan QR code to contact us
Documents / Resources
|
Nilight 10038W LED Light Bar Wiring Harness
Kit
[pdf] User Manual
10038W LED Light Bar Wiring Harness Kit, 10038W, LED Light Bar Wiring Harness
Kit, Bar Wiring Harness Kit, Wiring Harness Kit, Harness Kit
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>