Metalux UHB-12-UNV-L840-CD-U UHB LED Round High Bay Instruction Manual

: June 16, 2024
: METALUX

Table of Contents

Metalux UHB-12-UNV-L840-CD-U UHB LED Round High Bay
Wiring Diagram
INSTALLATION
FCC Statement
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Metalux UHB-12-UNV-L840-CD-U UHB LED Round High Bay

WARNING

Risk of Fire, Electrical Shock, Cuts or other Casualty Hazards- Installation and maintenance of this product must be performed by a qualified electrician. This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
Risk of Fire and Electric Shock- Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at fuse or circuit breaker.
Risk of Fire- Minimum 90°C supply conductors.
Risk of Burn- Disconnect power and allow the fixture to cool before handling or servicing.
Risk of Personal Injury- Due to sharp edges, handle with care.
Failure to comply with these instructions may result in death, serious bodily injury and property damage.

DISCLAIMER OF LIABILITY: Cooper Lighting Solutions assumes no liability for damages or losses of any kind that may arise from the improper, careless, or negligent installation, handling or use of this product.
IMPORTANT: Read carefully before installing the fixture. Retain for future reference.
NOTICE: Green ground screw provided in the proper location. Do not relocate.
NOTICE: The fixture may become damaged and/or unstable if not installed properly.
Note: Specifications and dimensions are subject to change without notice.
ATTENTION Receiving Department: Note the actual fixture description of any shortage or noticeable damage on the delivery receipt. File a claim for common carrier (LTL) directly with the carrier. Claims for concealed damage must be filed within 15 days of delivery. All damaged material, complete with original packing must be retained.

Wiring Diagram

INSTALLATION

Lock the hook. (Figure 1.)
Install and tighten the set screw. (Figure 2.)
Hang up the fixture. (Figure 3.)
Install the lock screw. (Figure 4.)

Wire Guard Installation

Install plastic spacers on screws, then feed through the eyelet on the wire guard and screw into the fixture. (Figure 5.)
Tighten all four screws. (Figure 6.)

Reflector Installation

Install all four screws into the mounting holes, leaving a 3mm gap from the fixture. (Figure 7.)
Align reflector keyhole slots with a screw and rotate the reflector clockwise until it stops. (Figure 8.)
Tighten all the screws. (Figure 9.)

installation of Mounting Bracket

Lock the 2pcs Bracket B on the lamp with screws. (Figure 10.)
Install Bracket A on Bracket B (Figure 11.)
Adjust the angle of Bracket A, and then lock it into place. (Figure 12.)

FCC Statement

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

Warranties and Limitations of Liability

Please refer to www.cooperlighting.com for our terms and conditions.

Cooper Lighting Solutions 1121 Highway 74 South Peachtree City, GA 30269