MARTHA STEWART MT120-0024 Harley Accent Tables Instruction Manual
- June 16, 2024
- Martha Stewart
Table of Contents
ASSEMBLY INSTRUCTIONS
Description: Harley Round Accent Table
Important safety instructions:
- Please read carefully all instructions before assembly.
- For your safety and ease, assembly by two or more adults is recommended.
- Keep instructions for future use.
Pre-assembly:
- Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
- Take out all parts and hardware from box.
Parts List
| Item | Description | QTY |
|---|---|---|
| P1 | Table Top | |
| P2 | Shelf | |
| P3 | Legs |
Hardware List
| Item | Description | QTY |
|---|---|---|
| H1 | Bolts @1/4™1-1/8″ | |
| H2 | Lock Washers Ø 1/4″ | |
| H3 | Flat Washers Ø 1/4″ (16mm) | |
| H4 | Allen Wrench 1/4” |
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT
LIABLE FOR ANY DAMAGES RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER
PURCHASE.
Assembly Procedures:
Step 1. Assemble the table on a flat, soft surface such as a carpet or
cloth to prevent scratching the finish.
Loosely attach the three legs (P3) to the bottom of table tap (P1) as shown
below.
(H1)x3 Bolts Ø1/4″*1-1/8″|
---|---
(H2)x3 Lock Washers Ø1/4″|
(H3)x3 Flat Washers Ø1/4″(16mm)|
(H4)x1 Allen Wrench 1/4″|
Step 2. Attach the shelf (P2) to the assembled legs (P3) as shown below.
(H1)x3 Bolts Ø1/4″*1-1/8″|
---|---
(H2)x3 Lock Washers Ø1/4″|
(H3)x3 Flat Washers Ø1/4″(16mm)|
(H4)x1 Allen Wrench 1/4″|
Step 3. Attach the fourth leg (P3) to the assembled shelf (P2) and table top (P1) as shown below.
(H1)x3 Bolts Ø1/4″*1-1/8″|
---|---
(H2)x3 Lock Washers Ø1/4″|
(H3)x3 Flat Washers Ø1/4″(16mm)|
(H4)x1 Allen Wrench 1/4″|
Step 4. Securely tighten all bolts with Allen wrench(H4), turn the
assembled table to an upright position, Assembly is complete.
Leveler adjustment: Levelers are pre-installed on the legs and adjust as
needed to make sure the table is leveled. Failure to follow these instructions
may cause the bolts to misalign during assembly.
ADDITIONAL NOTE ABOUT SAFETY:
BOLTS MAY LOOSEN DURING NORMAL EVERYDAY USE.
THEY SHOULD BE INSPECTED AT LEAST EVERY 3 MONTHS AND RE-TIGHTENED AS NEEDED TO
PREVENT DAMAGE OR INJURY, AND ENSURE STABILITY.
Thank you for your purchase
Documents / Resources
|
MARTHA STEWART MT120-0024 Harley Accent
Tables
[pdf] Instruction Manual
MT120-0024 Harley Accent Tables, MT120-0024, Harley Accent Tables, Accent
Tables, Tables
---|---