NiLIGHT ZH010 LED Light Bar Wiring Harness User Manual
- June 16, 2024
- Nilight
Table of Contents
NiLIGHT ZH010 LED Light Bar Wiring Harness
LED Light Bar Wiring Harness
Installation
- Connect light bar wires to wiring harness terminals respectively, black to black, red to red.
- Connect wiring harness to the car battery. Red wire (+) with fuse to positive, black wire(-) to negative
- Turn on the power and press switch on/off to test the light.
Caution
- The operating voltage is 12V DC
- 16AWG: Max. Wattage 180W
- 14AWG: Max. Wattage 300W
- 12AWG: Max. Wattage 450W
- Please make sure all the exposed wires were securely wrapped by electrical insulating tape to prevent short circuit.
- Please strictly follow the instructions to avoid any hazards. If you do not feel comfortable with the installtion we recommend having a professional to install or install under his guidance.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>