HOME DECORATORS COLLECTION HB3689-43 2 Light Ceiling Flush Mount User Guide

HOME DECORATORS COLLECTION HB3689-43 2 Light Ceiling Flush Mount

Safety Information

• Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box.
• Consult a qualified electrician if you have any electrical questions or need to replace the driver.
• If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-800-986-3460 or HOMEDEPOT.COM/HOMEDECORATORS .

WARNING : Disconnect the power prior to removing or installing a light fixture.

Warranty

WHAT IS COVERED

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service. If this product is found to be defective, the manufacturer’s only obligation, and your exclusive remedy, is the repair or replacement of the product at the manufacturer’s discretion, provided that the product has not been damaged through misuse, abuse, accident, modifications, alterations, neglect or mishandling.

WHAT IS NOT COVERED

This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the in the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any other failure not relating to faulty material or workmanship. This warranty shall not apply to instructions supplied with the product. This warranty shall not apply to a failure of the on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear.
The manufacturer does not warrant and specially disclaims any warranty, whether expressed or implied, of fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not limited to any labor/expense costs involved in the replacement or repair of said product.
Contact the Customer Service Team at 1-800-986-3460 or visit HOMEDEPOT.COM/HOMEDECORATORS.

Pre-Installation

PLANNING THE INSTALLATION
Read all instructions before assembly and installation. Before starting installation of the fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard.

NOTE : Keep your receipt and these instructions for Proof of Purchase.

TOOLS REQUIRED

HARDWARE REQUIRED

PACKAGE CONTENTS

Mounting the hardware

• Thread the fixture screws (EE) into the provided holes of the mounting bracket (FF).
• Thread the small hex nuts (BB) onto the fixture screws (EE). Do not tighten the small hex nuts (BB) at this time.
• Pull the supply wires out from the outlet box and mount the mounting bracket (FF) to the outlet box (GG) using the mounting screws (DD).
• Place the canopy (A) over the outlet box and onto the fixture screws (EE).
• Adjust the fixture screws (EE) until they protrude out from the fixture body (A) 1/4 in.
• Remove the fixture body (A) and secure the position of the fixture screws (EE) by tightening the small hex nuts (BB) against the mounting bracket (FF).

Connecting the wires

• Connect the black supply wire to the black fixture wire using a wire nut (CC).
• Connect the white supply wire to the white fixture wire using a wire nut (CC).
• Connect the supply ground wire to the fixture ground wire using a wire nut (CC).
• Add a cable tie below each wire nut to provide a more secure connection.

NOTE: If you have electrical questions consult your local electrical code for approved grounding methods.

Mounting the fixture Place the fixture body (A) over the fixture screws (EE) and secure the fixture body (A) with the thumb nuts (AA).

Installing the bulb

Install a 60W Incandescent bulbs (HH) or LED or CFL equivalent into each socket of the fixture body (A).

NOTE: Do not exceed a 60 watt incandescent light bulb or equivalent CFL or LED bulb.

Operation

• Turn on power at the circuit breaker or fuse box.
• Turn the light switch on to activate the fixture.

Care and Cleaning

EXTERIOR MAINTENANCE

Use a dry or slightly dampened clean cloth and wipe the surface of the fixture.

INTERIOR MAINTENANCE

• Disconnect power to the fixture by turning off the circuit breaker or by removing the fuse at the fuse box.
• Use a dry or slightly dampened clean cloth to wipe the interior surface of the fixture.

Troubleshooting

o Test or replace the switch.

o Check the wiring.

o Replace the light bulb.

The fuse blows or circuit breaker trips

when light is turned on.

| o Check the wire connections.

Questions, problems, missing parts? Before returning to the store, call Home Decorators Collection Customer Service
8 a.m. – 7 p.m., EST, Monday-Friday
9 a.m. – 6 p.m., EST, Saturday
1-800-986-3460
HOMEDEPOT.COM/HOMEDECORATORS
Retain this manual for future use.

References

• Home Decorators Collection - Home Decor - The Home Depot

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>